INSTALLATION
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1Check gasket seal around top, bottom, and sides of freezer drawer.
2If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.
Remove Hex | Remove Hex |
Head Drawer | Head Drawer |
Screw | Screw |
Do Not Remove | Do Not Remove |
Other Screws | Other Screws |
Remove Hex | Remove Hex |
Head Drawer | Head Drawer |
Screw | Screw |
3Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.
Most of these conditions can be met by raising or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration).
2You can raise or lower each door. use a 3/8 inch socket wrench to turn the adjustment screws (1 per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
3Ensure both doors are
4After unit is leveled, lower
Push Against Freezer Drawer
A
B
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
Door | Door |
4Tighten four (4) drawer screws.
5Recheck gasket seal.
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for final positioning of your refrigerator:
•All four corners of the cabinet must rest firmly on the floor.
•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).
•Doors should align with each other and be level.
Raise |
Leg |
Lower |
5Install the toe grille by fitting into place.
6