Frigidaire DGHF2360PF important safety instructions Options May Vary, Setting cooling temperatures

Options May Vary

options	Used to enter and exit the
(∧ or ∨)	options menu and make
	selections.
exit	Toggles the options and run
	modes.
control	While in the locked state,
locked	you will not be able to
	change any settings on the
	display nor dispense ice and
	water. The “Control Locked”
	indicator will flash and an
	audible warning tone is
	played.
quick	Activates a faster rate for
freeze on	freezing food and increases
off	ice production in the freezer.
	Deactivates after 12 hours.
ice maker	Toggles the ice maker “ON”
on off	or “OFF”. In the “Ice Off”
	state, indicator will blink
	when ice is dispensed.
display	Toggles the temperature
on off	displays On and Off.
refrigerator	Allows the temperature set-
temp	points to be adjusted. Control
	temperatures range from
	+33° F / +1° C to +47° F /
	+8° C.
freezer	Allows the temperature
temp	set-points to be adjusted.
	Control temperatures range
	from -6° F / -21° C to +6° F
	/ -15° C.
mode ° F	Toggles display from
° C	Fahrenheit to Celsius.
light	Toggles dispenser light On
	and Off.
power off	Press and hold for three
	seconds to turn off the
	cooling system. It also turns
	off the ice maker and all
	dispenser functions. The
	display will read “power off”.
water filter	Displays the current status of
	the water filter (Good, Order,
	or Replace). To reset the filter
	status to “Good”, press and
	hold the “set” key for three
	seconds.

	CONTROLS
air filter	Displays the current status of
	the air filter (Good, Order, or
	Replace). To reset the filter
	status to “Good”, press and
	hold the “set” key for three
	seconds.
default	While in the default option,
settings	press and hold the set key
	for three seconds to reset all
	refrigerator settings to their
	factory default settings.
set (+ or -)Selects the current menu
	selection option.
water	Press the “water” key
	to select water. A green
	indicator light will be
	illuminated above the active
	feature.
cube	Press the “cube” key to
	select cubed ice. A green
	indicator light will be
	illuminated above the active
	feature.
crush	Press the “crush” key
	to select crushed ice. A
	green indicator light will be
	illuminated above the active
	feature.

Setting cooling temperatures

(options may vary)

NOTE

When you first power on the refrigerator, the temperature displays 0° F and 37° F. After a few seconds, both of the displays will switch to “HI”. The displays will continue to show “HI” for 20 minutes. After 20 minutes, the High Temp alarm will sound and both displays will show the actual temperature.

1Plus (+) and Minus (-) indicators are located on the right side of the control panel.

2Press the + or - indicator to adjust the temperature to the desired setting.

19