INSTALLATION
This Owner’s Guide provides specific operating instructions for your model. Use the refrigerator only as instructed in this Use & Care Manual. Before starting the refrigerator, follow these important first steps.
LOCATION
•Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug.
•If possible, place the refrigerator out of direct sunlight and away from the range, dishwasher or other heat sources.
•The refrigerator must be installed on a floor that is level and strong enough to support a fully loaded refrigerator.
•Consider water supply availability for models equipped with an automatic ice maker.
INSTALLATION
CAUTION
Do Not install the refrigerator where the temperature will drop below 55°F (13°C) or rise above 110°F (43°C). The compressor will not be able to maintain proper temperatures inside the refrigerator.
Do Not block the toe grille on the lower front of your refrigerator. Sufficient air circulation is essential for the proper operation of your refrigerator.
Installation Clearances
•Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections:
Sides & Top
DOOR OPENING
NOTE
If you refrigerator is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider.
Your refrigerator should be positioned to allow easy access to a counter when removing food. For best use of drawers and freezer baskets, the refrigerator should be in a position where both the refrigerator and freezer doors can be fully opened.
TOE GRILLE INSTALLATION / REMOVAL
To InstallToe Grille:
1.Open freezer and fresh food compartment doors.
2.Line up toe grille at base of refrigerator, making sure the four bottom tabs are resting through holes at base of cabinet.
3.Starting from left side of toe grille, press in on first top tab using your thumb and push toe grille forward until it snaps in place. Continue this process until all tabs are snapped in place and toe grille is secured to refrigerator.
To Remove Toe Grille:
1.Open freezer and fresh food compartment doors.
2.Working from left side of toe grille, slip your fingers
between top of toe grille and cabinet. Gently pull forward until first set of
tabs are free. Slide
your hand down past the free tabs and pull
forward again until the
second set of tabs are free. Continue this process until all tabs
are free and the toe grille can be removed. (See graphic at top of page in right column.)
LEVELING
All four corners of your refrigerator must rest firmly on a solid floor. Your refrigerator is equipped with adjustable front rollers to help level your unit. To ensure proper door seal and assist door closing, the refrigerator should be tilted 1/4” (6 mm), front to back.
To LevelYour Refrigerator:
1.Remove toe grille. (See “To Remove Toe Grille” .)
2.Use
NOTE
The refrigerator doors are designed to shut by themselves within a 20 degree opening.
3.Check both doors to be sure seals touch cabinet on all four sides.
4