Frigidaire FHWC3060LS, FHWC3660LS, FHWC3655LS Installing the hood, Intended use, Parts supplied

Installing the hood 5

•Do not have a fuse in the neutral or ground circuit.

IMPORTANT

Save installation instructions for electrical inspector’s use.

The range hood must be connected with copper wire only.

The range hood should be connected directly to the fused disconnect (or circuit breaker) box through metal electrical conduit.

Wire sizes must conform to the requirements of the National Electrical Code ANSI/NFPA 70 – latest edition”, or CSA Standards C22.1-94, Canadian Electrical Code Part 1 and C22.2 No.0-M91 – latest edition** and all local codes and ordinances.

A U.L.- or C.S.A.-listed conduit connector must be provided at each end of the power supply conduit (at the range hood and at the junction box).

Copies of the standards listed may be obtained from:

*National Fire Protection Association Batterymarch Park Quincy, Massachusetts 02269

**CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575

Power requirement:

120V~, 60Hz, 15 or 20A branch circuit

Intended use

•Your range hood is intended for exhaust operation only. This range hood is not recommended to be used over indoor grills. Do not use it to exhaust hazardous or explosive materials or vapors.

Parts supplied

No. Part		Qty.
1	Range hood	1

2 Glass cover 1

		Upper and lower	1
3			+
		chimney
			1
4		Upper bracket	1
5		Lower bracket	1
6		Collar	1
		Recirculation kit
7		(optional	1
		accessories)
		-FHWRKT60LS
		Bulb
8		20W, 120V~, GU10	2
		(pre-assembled)
9		Bolt, rubber	4
		washer, washer	sets
10		Long screw	8
		(4mm x 32mm)
11		Wall plug	8
12		Short screw	4
		(4mm x 12mm)
13		Allen key	1
		Wood screw
14		(4mm x 50mm)	4
		Short screw
		(3.5mmx8mm)
15		Short screw	2
		(3.5mmx8mm)
		10’ extension
		chimney kit
16		(optional	1
		accessories)
		FHW10X60LS
17	Template	Assembly template	1
	(stencilled)	(stencilled)

GB