General Cleaning (continued)
To Remove and Replace Oven Door (side swing door models) (some models)
To Remove Oven Door:
1.Pull the door open.
2.While supporting the door with one hand, remove the 2 screws securing the top hinge to the door.
3.Remove the top hinge, then lift up the door to clear the lower hinge pin and remove the door.
To Replace Oven Door:
1.Insert the door into the lower hinge.
2.Replace the top hinge, and secure it to the door with the 2 screws.
Changing Oven Light
On some models an interior oven light will turn automatically when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the control panel. On some models, the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. 
Turn the power off at the main source.
2.Wear a
3.Replace bulb with 40 watts appliance bulb only.
4.For models with glass shield, press wire holder on one side to release glass shield, change bulb and be sure to replace the glass shield.
Adjusting Oven Temperature
To adjust the oven temperature, for instructions refer to the timer section or the electronic oven control.
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.
OCCURRENCE | POSSIBLE CAUSE/SOLUTION |
|
|
Oven Control Beeps and Displays -F1- or -F3-.
Electronic control has detected a fault condition. Push the CANCEL pad to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number, push CANCEL pad and contact an authorized servicer.
Installation. | Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if |
| |
|
| rack and cabinet cutout flooring are not level. |
|
|
|
|
|
|
| Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are |
|
|
| square and level. Contact cabinet maker to correct problem. |
|
|
|
|
|
Entire oven does not operate. | When the oven is first plugged, or when the power supply to the oven has been interrupted, |
| |
|
| the display will flash. The oven cannot be programmed until the clock is set. |
|
|
|
|
|
|
| Be sure electrical cord is securely connected into the electrical junction box. |
|
|
|
|
|
|
| Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your |
|
|
| dealer, installing agent or authorized servicer. |
|
|
|
|
|
|
| Service wiring not complete. Contact your dealer, installing agent or authorized servicer. |
|
10