Frigidaire 318200964 Oven Control Beeps, Displays an F, Error Code, Faulty Installation, Operate

Page 22

Before you call - Solutions to Common Problems

IMPORTANT

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

 

 

Oven Control Beeps

Electronic control has detected a fault condition. Push CLEAR pad to clear the display and stop

and Displays an “F”

the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number,

Error Code

push the CLEAR pad and contact an authorized servicer.

 

 

Faulty Installation

Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if

 

rack and cabinet cutout flooring are not level.

 

Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are

 

square and level. Contact cabinet maker to correct problem.

Entire Oven Does Not When the oven is first plugged in, or when the power supply to the oven has been interrupted,

Operate

the display will flash. The oven cannot be programmed until the clock is set.

 

Be sure electrical cord is securely connected into the electrical junction box.

 

Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your

 

dealer, installing agent or authorized servicer.

 

Service wiring not complete. Contact your dealer, installing agent or authorized servicer.

 

Power outage. Check house lights to be sure. Call your local electric company.

 

Short in cord/plug. Replace cord/plug.

 

Controls are not set properly. See instructions to set the controls.

 

House fuse has blown or circuit breaker has tripped immediately following installation.

 

House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.

 

 

Oven Light Does Not

Burned-out or loose bulb. Follow the instructions under Oven Light to replace or tighten the

Work

bulb.

Self-Cleaning Cycle

Make sure the oven door is closed.

Does Not Work

Controls not set properly. Follow instructions under “Using the Self-Clean Feature”.

 

 

 

Oven Smokes

Meat too close to the broiler element. Reposition the rack to provide more clearance between

Excessively During

the meat and the broiler. Preheat broil element for quick searing operation.

Broiling

Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to

 

 

prevent curling, but do not cut into the lean.

 

Grid on broiler pan wrong side-up. Grease does not drain into broiler pan. Always place the grid

 

on the broiler pan with the ribs up and the slots down to allow grease to drip into the pan.

 

Broiler pan used without grid or grid cover with aluminum foil. DO NOT use the broiler pan

 

without the grid or cover the grid with aluminum foil.

 

Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is necessary

 

when broiling frequently. Grease or food spatters cause excessive smoking.

 

 

Soil Not Completely

Failure to clean bottom, from top of oven, frame of oven or door area outside oven seal. These

Removed After Self-

areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these

Cleaning Cycle is

areas before the self-cleaning cycle is started. Burned on residue can be cleaned with a stiff

Completed

nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.

 

Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.

 

 

Poor Baking Results

Many factors affect baking results. See Baking for hints, causes and corrections. See Adjusting

 

Oven Temperature.

 

 

Flames Inside Oven

Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie spillovers

or Smoke from Vent or for large amounts of grease on bottom of oven. Wipe up excessive spillovers.

22

Image 22
Contents Use &Care Register Your Product Welcome & CongratulationsPlease Carefully read and save these instructions Important Safety Instructions DefinitionsImportant Safety Notice Oven Ignition Grounding instructionsConversion to liquefied petroleum gas or L.P. gas Features AT a Glance model a Your Gas Wall-Oven FeaturesFeatures AT a Glance Model B Air Circulation in the Oven Oven Vent LocationArranging Oven Racks To Set the Minute Timer Setting Oven controls Model aTo Change the Temperature Display Mode Press Timer ON/OFF padTo Broil To Set or Change the Temperature for BakingAdjusting Your Oven Temperature Failure ModesOven can be programmed to Setting Oven controls Model BTemperature Conversion Fahrenheit/Celsius For a silent control panelTo Set Control for Continuous Bake or 12 Hour Energy Saving Push Timer ON/OFF padTo Set Control for Oven Lockout feature To Set Control for Oven LockoutTo Set the Controls for Normal Baking To Set or Change the Temperature for Normal BakingSetting Broil Broiling TipsWhen the Set Bake Time Runs Out To Set the Bake time FeatureRecalibrating Your Oven Temperature Once the Controls are SetAdhere to the following cleaning precautions Self-cleaningWhat to Expect during Cleaning To Set the Controls for a Self-Clean Cycle To Start the Self-Clean CycleWhen the Self-Clean Cycle is Completed Care & Cleaning Cleaning Various Parts of Your RangeGeneral Cleaning Care & CleaningNon Self-Clean Oven Model a Cleaning the Oven BottomTo Remove and Replace Oven Bottom Broiler Drawer Model a or Storage Drawer Model BRemoving and replacing the lift-off oven door Care and cleaning of stainless steelChanging oven light Baking Problems and Solutions Chart Oven BakingSelf-Cleaning Cycle Error CodeFaulty Installation Cleaning Cycle isPage If You Exclusions This warranty does not cover the followingService Need

318200964 specifications

The Frigidaire 318200964 is a high-quality replacement part designed for a range of Frigidaire cooking appliances. Recognized for its reliability and efficiency, this component is essential in ensuring that your oven functions smoothly. The 318200964 is primarily known as a range surface burner control knob, which plays a critical role in regulating the flame intensity of the burners.

One of the main features of the Frigidaire 318200964 is its impressive compatibility. This part is not only designed for Frigidaire models but also fits various brands within the same appliance category. This versatility makes it an ideal choice for those looking to replace an old or malfunctioning burner control knob without the hassle of replacing the entire stovetop unit.

Durability is another characteristic that sets the 318200964 apart from other replacement parts. Constructed from high-quality materials, it is specifically designed to withstand the heat and demands of everyday cooking. This sturdy design helps maximize the lifespan of the product, ensuring that it can handle both casual cooking and more intense culinary endeavors.

In terms of operation, the Frigidaire 318200964 features easy-grip styling, which allows for precise control over burner settings. The intuitive design ensures that users can easily adjust the flame, helping to achieve the perfect cooking temperature for a variety of dishes. Whether you are simmering sauces, boiling pasta, or searing meats, this control knob provides an excellent user experience.

Technologically, the 318200964 is designed to be straightforward in its installation process. Homeowners can replace their malfunctioning knob with minimal tools, often requiring just a simple screwdriver. The straightforward design not only saves time but also allows for easy upkeep of your cooking appliance.

In conclusion, the Frigidaire 318200964 burner control knob combines compatibility, durability, ease of use, and simple installation. It is an essential component for anyone looking to maintain the functionality of their Frigidaire range or similar appliances, ensuring that culinary creativity can flourish without interruption. This replacement part makes everyday cooking a breeze, allowing home chefs to focus on creating delicious meals rather than worrying about appliance performance.