Frigidaire 318200929 warranty Adjusting Your Oven Temperature, Before you call

Page 14

Care & Cleaning

To remove the “hidden bake” cover:

1.In order to remove the “hidden bake” cover, pull the back edge with one hand about 1/2" inch and lift up the “hidden bake” cover with both hands. (See picture)

2.When re-installing the “hidden bake” cover, be sure to put it all the way to the back of the oven and lay it down on the 2 shoulder screws. Then push the front edge of the cover in its place below the front bracket.

To have easier access to the "hidden bake" cover, you can remove the oven door by following the instructions on previous page.

IMPORTANT: Always replace the “hidden bake” cover before the next use.

Adjusting Your Oven Temperature

For instructions on how to adjust the oven temperature refer to the electronic oven control guide.

Before you call

Solutions to Common Problems

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

 

 

Oven Control Beeps and Displays any F code (for exemple F11).

Electronic control has detected a fault condition. Push CLEAR pad to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number, push the CLEAR pad and contact an authorized servicer.

-F8- is displayed.

The door was left open and controls set for self-cleaning cycle. Close the door and push both upper and lower oven CLEAR pads.

Installation.

Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent

 

if rack and cabinet cutout flooring are not level.

 

 

 

Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets

 

are square and level. Contact cabinet maker to correct problem.

Entire oven does not operate.

When the oven is first plugged in, or when the power supply to the oven has been interrupted, the display will flash. The oven cannot be programmed until the clock is set.

Be sure electrical cord is securely connected into the electrical junction box.

Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your dealer, installing agent or authorized servicer.

Service wiring not complete. Contact your dealer, installing agent or authorized servicer.

Power outage. Check house lights to be sure. Call your local electric company.

Short in cord/plug. Replace cord/plug.

Controls are not set properly. See instructions under Setting Oven Controls to set the controls.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Warranty Before SettingCare & Cleaning 10-13 Adjusting Your WelcomeSerial Plate Location Welcome & CongratulationsProduct Registration Questions?Important Safety Instructions SELF-CLEANING Oven Models Important Instructions for Using Your OvenImportant Instructions for Cleaning Your Oven Features At a Glance Your Electric Wall Oven Features At a GlanceAir Circulation in the Oven Before Setting Oven ControlsSetting Oven Controls Arranging Oven RacksCooking Informations Oven BakingBroiling Convection notes Convection Cooking some modelsConvection Roasting some models Oven Racks Care & CleaningStainless Steel, Chrome Control Panel, Decorative Trim Oven DoorSelf-Cleaning Oven Self-Cleaning some modelsTo Set the Self-Clean Cycle Adhere to the following cleaning precautionsGeneral Cleaning Cleaning the Manual Clean Oven Regular oven models onlyCare and Cleaning of Stainless Steel some models To Clean the Oven BottomChanging the Oven Light Removing and Replacing the Oven DoorSpecial Door Care Instructions Before you call Adjusting Your Oven TemperatureOccurrence Possible CAUSE/SOLUTION To remove the hidden bake coverOccurrence Possible Cause / Solution Oven light does not workLimited Warranty Your Wall Oven is protected by this warrantyCaractéristiques Réglage des commandesMesures de sécurité Avant l’utilisationEnregistrement de l’appareil Emplacement de la plaque de sérieBienvenue et félicitations Des questions?Voyez les instructions dinstallation Mesures de sécurité importantesInstructions Importantes Pour Lutilisation DE Votre Four Instructions Importantes Pour LE Nettoyage DE Votre FourDe votre four encastré Caractéristiques de lappareilLes caractéristiques Avant l’utilisation du four Réglage des commandes du fourInstallation des grilles Circulation de l’air dans le fourInformations de cuisson Cuisson au fourCuisson au gril Conseils sur la convection Cuisson par convection certains modèlesRôtissage par convection certains modèles Porte du four Entretien et nettoyageGrilles du four Réglage des commandes du four pour un cycle autonettoyant Préparation au cycle d’autonettoyagePour enlever la saleté accumulée Suivez les précautions de nettoyage suivantesNettoyage général Pour nettoyer le fond du fourInstructionsspécialespourl’entretiendelaporte Enlever et réinstaller la porteRemplacement de lampoule du four Ajustement de la température du four Avant de faire appel au service après-venteProblème Cause Possible /SOLUTION Enlever le couvercle de lélément caché certains modèlesProblème Cause Possible / Solution Lampoule du four ne fonctionne pasGarantie Limitée Votre appareil est protégé par cette garantie
Top Page Image Contents