Frigidaire 318205308 Care & Cleaning, Removing and Replacing the Lift Off Oven Door

Page 25

Removing and Replacing the Lift-

Off Oven Door

CAUTION

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor -

See Figure 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Figure 2). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 4).

To Replace Oven Door:

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 4). The hook of the hinge arms must be fully seated onto the roller pins.

3.Fully open the oven door (horizontal with floor - See

Figure 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Figure 2) to the locked position.

5.Close the oven door.

Door Hinge locations

with oven door fully open

Care & Cleaning

Around

Oven door

 

Hinge

 

Figure 3

Figure 4

Special Door Care Instructions - Most oven doors contain glass that can break.

Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Changing Oven Light

CAUTION

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.

To Replace the Light Bulb:

CAUTION

BE SURE OVEN IS COOL

1.

Turn the power off at the main source.

2.

Wear a leather-faced glove for protection against

 

possible broken glass.

3.

Replace bulb with a 40 Watt appliance bulb only.

Figure 1

Figure 2

4. For self-cleaning oven, press wire holder to one side to

release glass shield, change bulb

and be sure to replace glass shield.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Use &Care Register Your Product Welcome & CongratulationsPlease Carefully read and save these instructions Definitions Important Safety InstructionsDo not Touch Interior Oven Elements Important Safety Instructions for Cleaning Your Oven Important Safety Instructions for Using Your OvenYour electric wall oven features Features AT a GlanceOven Vent Location Before Setting Oven ControlsArranging Oven Racks Air Circulation in the OvenOffset Oven Rack Types of Oven RacksControl Pad Features Before Setting Oven controlsConvect Convert PAD-Use to convert Temperature Visual Display Setting Oven controlsMinimum and Maximum Control Pad Settings Feature Minimum TEMP. /TIME Maximum TEMP. /TIMESetting Temperature Display Fahrenheit or Celsius Setting the ClockSetting Continuous Bake or 6 Hour Energy Saving Setting Silent Control OperationSetting +1 Min Feature Setting Minute TimerSetting Oven Lockout Feature Setting Bake Setting Power PreheatTo set the Preheat temperature for 375F To set the Bake Temperature to 375FSetting Convection Bake Setting Oven ControlsConvection Baking Tips Air circulation during Convection BakeSetting Convection Roast Setting Convection CONVERsionTo set a Convection Roast Temperature of 375F Convection Roasting TipsTo set a Convection Broil Temperature of 500F Setting Convection BroilConvection Broiling Tips Electric Oven Convection Broiling Table RecommendationsSetting Delay Start Setting Bake TimeWhen the timed bake finishes BAKE, Convection BAKE, Bake Time and DelayCancel Setting BroilBroiling Tips Electric Oven Broiling Table RecommendationsSetting Pizza Setting NuggetsSetting Favorite Setting WarmSetting Oven Controls To adjust the oven temperature higher Adjusting Oven TemperatureTo adjust the oven temperature lower Oven lightAdhere to the following cleaning precautions SELF-CLEANINGWhat to Expect during Cleaning Setting a Delayed Start SELF-CLEAN Cycle Setting a SELF-CLEAN CycleWhen the Self-Clean Cycle is Completed Stopping or Interrupting a Self-Cleaning CycleCleaning Various Parts of Your Range Care & CleaningRemoving and Replacing the Lift Off Oven Door Care & CleaningChanging Oven Light Be Sure Oven is CoolOven Baking Baking Problems and Solutions ChartOccurrence Possible CAUSE/SOLUTION Exclusions This warranty does not cover the following Major Appliance WarrantyDisclaimer of Implies Warranties Limitation of Remedies

318205308 specifications

The Frigidaire 318205308 is a versatile and innovative appliance component designed to enhance kitchen efficiency and functionality. This particular model serves as a crucial replacement part for various Frigidaire range ovens, ensuring optimal performance while maintaining the durability that the brand is known for.

One of the standout features of the Frigidaire 318205308 is its compatibility with multiple oven models, ensuring that users do not have to purchase an entirely new unit in case of a malfunction. This versatility is a significant cost-saving advantage, allowing homeowners to easily replace worn or damaged parts instead of replacing the entire appliance.

The Frigidaire 318205308 is crafted from high-quality materials, ensuring longevity and resistance to wear and tear. Its robust construction means it can withstand the high temperatures typically found in home cooking environments, making it a reliable choice for everyday culinary needs.

In terms of technology, this component incorporates advancements that enhance its efficiency. Its design minimizes heat loss, contributing to more uniform cooking results. This is particularly important for baking, where even heat distribution is critical for achieving the perfect rise in baked goods.

Another characteristic that sets the Frigidaire 318205308 apart is its user-friendly installation process. Most users can replace the part without professional help, making it an ideal solution for those who prefer DIY projects. Detailed instructions are often provided, ensuring that even novice users can complete the installation with confidence.

The Frigidaire brand is synonymous with quality and dependability, and the 318205308 is no exception. It not only meets the rigorous standards set by the company but also aligns with the expectations of today's discerning consumers who prioritize reliability and performance in their kitchen appliances.

In summary, the Frigidaire 318205308 is a must-have component for any kitchen equipped with a Frigidaire range oven. Its compatibility, durability, modern technology, and ease of installation make it an essential part of maintaining an efficient cooking environment. Whether performing regular maintenance or addressing specific issues, this component ensures that cooking remains a seamless and enjoyable experience.
Top Page Image Contents