Built-In All-Freezer Specifications

All Freezer

FPUH19D7L F 19 Cu. Ft.

•Product Weight – 247 Lbs.

•An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (NFPA 70) and local codes & ordinances.

•Voltage Rating – 120V / 60 Hz / 20 Amps

•Connected Load (kW Rating) @ 115 Volts = 0.55 kW

•Amps @ 115 Volts = 5 Amps

•Always consult local and national electric & plumbing codes.

•Water line for ice maker can enter opening through floor or rear wall Copper tubing recommended between cold water line and water connection location. Water line tubing recommended is 48" minimum length by 1/4" diameter. Installation of easily accessible shutoff valve in water line required.

•Minimum 25-1/4" depth requires recessed electrical outlet and copper water line.

•To allow for ease of installation, tape excess power cord to back of unit.

•To allow for ease of moving out side-by-side units after installation, 84" minimum length of coiled copper tubing recommended.

•When installing freezer adjacent to wall, cabinet or other appliance that extends beyond front edge of unit, 20" minimum clearance recommended to allow for optimum 140° door swing, providing complete drawer / crisper access and removal. (Absolute 4" minimum clearance will ONLY allow for 90° door swing which will provide limited drawer / crisper access with restricted removal.)

•Freezer must be placed on level surface of hard material, same height as flooring. Surface must support approximately 800 lbs. when fully loaded. Unit equipped with 4-point leveling.

“Built-In Look” Specifications

•Minimum opening of 72" H x 33" W x 25-1/4" D required for single- unit “Built-In Look” installation; 66" W required for double-unit installation. (72" H to be measured from finished floor to underside of soffit or overhead cabinet.)

•Remove all wall / floor molding prior to built-in installation.

Optional Trim Kit Specifications

•If optional Single or Double Louvered Trim Kit is to be used, different cutout dimensions are required. Kit can be adapted to fit either 75" or 79" opening height. (Refer to cutout dimensions on this page and detailed Louvered Trim Kit installation instructions included with kit or on web.)

•Remove all wall / floor molding prior to built-in installation.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

Optional Accessories

•Single Louvered Trim Kit – (PN # TRIMKITEZ1).

•Double Louvered Trim Kit – (PN # TRIMKITEZ2).

•PureAdvantage® Air Filter

Replacement Cartridge – (PN # 241754001).

	USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com	Specifications
	CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca	Specifications
		subject to change.

FPUH19D7L 09/11

Printed in the U.S.A.