Connecting and Disconnecting the Portable/
Convertible Dishwasher
The portable/convertible dishwasher must be connected to a faucet and electrical outlet each time it is used. Follow directions on this page to properly connect dishwasher.
Faucet Adapter Assembly
For Outside | For Inside |
Threaded | Threaded |
Faucet | Faucet |
Use Thin | Use Thick and |
Washer Only | Thin Washers |
Adapter | Two Brass Screens |
(Dual Thread) | should be below |
| the rubber washers |
Connecting the Portable Faucet
Adapter Assembly
Collar
Coupler
IMPORTANT: Make sure door is latched before moving dishwasher.
The power cord, faucet coupler and hoses are located in a compartment in back of dishwasher. A special adapter must be installed on faucet before you can connect dishwasher.
1.Remove faucet adapter assembly from literature package.
2.Unscrew existing sink faucet aerator.
3.Check faucet spout to see if threads are inside or outside.
•If threads are on inside of faucet spout, use both thick and thin rubber washers.
•If threads are on outside of faucet spout, use thin rubber washer only.
•If faucet has no threads, an adapter kit with instructions for attachment to a
4.Assemble faucet spout as shown. Make sure the two brass screens are located below the rubber washers.
Connecting the Portable/Convertible Dishwasher
1.Run water at faucet until it is hot. Turn off faucet.
2.Pull hoses out of compartment.
3.Push collar down and slip faucet connector onto faucet adapter.
4.When connector snaps into place, release collar.
5.Slowly turn on hot water all the way.
6.Plug power cord into grounded outlet.
11