Electrical Information

These guidelines must be followed to ensure that safety mechanisms in the design of this appliance will operate properly.

Avoid fire hazard or electric shock. Do not use an extension cord or an adapter plug. Do not remove any prong from the power cord.

•Refer to the serial plate for correct electrical rating. The power cord of the appliance is equipped with a three-prong grounding plug for protection against shock hazards. It must be plugged directly into its own properly grounded three-prong receptacle, protected with a 15 amp time delay fuse or circuit breaker. The receptacle must be installed in accordance with the local codes and ordinances. Consult a qualified electrician. Receptacles with Ground Fault Circuit Interrupters (GFCI) are

NOT RECOMMENDED. DO NOT USE AN EXTENSION

CORD OR AN ADAPTER PLUG.

•If the voltage varies by 10 percent or more, appliance performance may be affected. Operating the appliance with insufficient power can damage the motor. Such damage is not covered under the warranty. If you suspect your voltage is high or low, consult your power company for testing.

•To prevent the appliance from being turned off accidentally, do not plug the unit into an outlet controlled by a wall switch or pull cord.

•DO NOT pinch, knot, or bend the power cord in any manner.

Other Precautions

•NEVER unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle.

•To avoid electrical shock, unplug the appliance before cleaning.

NOTE: Turning the control to “OFF” turns off the compressor but does not disconnect power to other electrical components.

Installation and Setup

Inspection for Damage

Inspect the underside of the cabinet and packaging for damage such as a fork truck can cause. If hidden damage is found after uncrating, immediately call the delivery carrier and request an inspection. Retain all packaging and crating materials until the inspection is complete.

Uncrating and Set-up

•Using a utility knife with a sharp, short blade, cut along the perimeter of the carton as indicated.

•Lift the carton off the product.

•Remove the package containing the casters from the unit. This package will contain the following items:

•One (1) wrench

•Sixteen (16) screws

•Four (4) casters

Casters

•With an assistant, tilt the unit until it is resting on its back. Take care to protect the back from being scratched during this process.

•Using the wrench provided and the sixteen (16) screws, install all four (4) casters in the tapped holes in the bottom of the unit. Tighten the screws securely.

•With an assistant, tilt the unit back up onto its casters.

•To prevent unintended movement, block casters once the unit is in place.

Appliance Placement

Leave a three (3) inch space on all sides and the back of the cabinet for adequate air circulation. Choose a place that is near a grounded electrical outlet. For the most efficient operation, the appliance should be located where surrounding temperatures will not drop below 40ºF (43ºC) or exceed 110ºF (43ºC). Additional compressor heaters are not recommended.

Insulation

The insulated space on this cabinet is sealed to maintain peak efficiency. DO NOT drill holes in the cabinet. Holes drilled in the cabinet may destroy that seal and damage electrical wiring located in the insulated space. It may also pierce and damage the sealed refrigeration system in the insulated space.

DAMAGED ELECTRICAL WIRING OR WET INSULATION CAUSED BY DRILLING WILL VOID THE WARRANTY.