To Set for Broiling:
1.Arrange the oven rack while oven is still cool. Position the rack as suggested in the Broil Rack Position Table below.
. Press _.,,m m "will appear in display.
3.Press and hold the A or V until the desired broil setting level appears in
the display. Press the A for HI broil or the V for LO broil. Most foods
may be broiled at the HI broil setting. Select the LO broil setting to avoid |
|
excess browning or drying of foods that should be cooked to the | Fig.l (some models) |
stage. |
|
4.For optimum browning, preheat broil burner for 3 - 4 minutes before adding food.
5.Place the insert on the broil pan (if equipped), then place the food on the insert (if equipped; See Fig. 1).
6.Place the broiler pan and insert on the oven rack (if equipped). Close the oven door.
7.Broil on one side until food is browned. Turn and broil food on 2nd side. Note: Always pull the oven rack out to the stop position before turning or removing the food.
8.When broiling is finished press @.
Broil Rack Position Table (Refer to Fig. 2)
Rack Postion from Top | Food category |
6th rack position | |
5th rack position | Fish, steaks & pork chops |
4th rack position | |
To insure proper results when broiling use approved Broil Pan & | |
Insert. | Fig. 2 |
Should an oven fire occur, close the oven door and turn the oven OFF. If the fire continues, use a fire extinguisher. DO NOT put water or flour on the fire. Flour may be explosive.
The broiler pan and the insert allows grease to drain and be kept away from the high heat of the broiler. DO NOT use the pan without the insert. DO NOT cover the insert with foil; the exposed grease could ignite. DO NOT use the broil pan without the insert or cover the insert with aluminum foil. The exposed fat could ignite.
To Operate the interior Oven Lights
The interior oven lights will automatically turn ON when the oven door is opened. Press _ to turn the interior oven lights ON or OFF whenever needed.
The interior oven light is located at the upper left rear wall of the oven interior and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. To change the interior oven light, see "Changing the Oven Light" in the General Care & Cleaning section.
13