Electrolux SIG 505 X Connecting to GAS, Connection to the Electricity Supply

Page 47

4. CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance. NOTE:

ONLY LIQUID SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED TO SHUT OFF VALVE I.E.: DO NOT USE P.T.F.E. SEALANT TAPE. Check for gas soundness after connecting to the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig.3. Take into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

50 100

850

Fig.3

700

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

250

450

All dimensions in

mm

5. CONNECTION TO THE ELECTRICITY SUPPLY

WARNING: THIS APPLIANCE MUST BE EARTHED. DO NOT EARTH THIS APPLIANCE TO THE GAS SUPPLY PIPING.

This appliance must be connected to 220V-240V A.C. 50Hz supply. It is supplied with 2 metres of 5 amp 3 core cable incorporating a moulded 13 amp plug , fitted with a 3 amp fuse, which can be plugged directly into the nearest suitable socket. If this is not long enough, the supply cable can be replaced totally by a longer cable at least 0.75mm² nominal cross sectional area (24/0.2mm).

IF THE MOULDED PLUG IS CUT FROM THE CABLE

 

FOR ANY REASON, IT MUST BE DESTROYED OR

 

DISPOSED OF SAFELY, AS THE PROTRUDING

 

WIRES WILL BE AN ELECTRIC SHOCK HAZARD.

 

If any other type of plug is used it should incorporate a 3

Fig.4

amp fuse in either the plug or adapter or at the distribution

 

board.

If the cable has to be threaded through small apertures in cabinets etc., it may be disconnected from the appliance, then re-connected to as shown in Fig.4.

DO NOT EXTEND THE CABLE USING PLASTIC OR CERAMIC CONNECTION TERMINAL BLOCKS AND/OR INSULATION TAPE.

ALL EXTERNAL WIRING BETWEEN THE APPLIANCE AND THE ELECTRICAL SUPPLY SHALL COMPLY WITH I.E.E. WIRING REGULATIONS.

47

Page 46 Page 48
Image 47
Page 46 Page 48
Contents SIG 505 Introduction For your safetyContents Hotplate Lighting the applianceSecond oven Leave the grill door open when you are using the grillGrill/second oven GrillOven light Main ovenTo turn off any burner Heat control Prior to using the grillGrill control has two heat settings GrillPositioning food on the grid Cooking positionsGeneral PreheatingGrill pan should be fitted with the handle for grilling Grill pan and handleBurner sizes HotplateAre reaching across the hotplate Take care to avoid burns and scalds when youHelpful hints Oven shelves OvensHeat zones Baking trays and dishes Condensation RoastingOven cooking chart Main oven 205 mm ½ 2¾ hours Mins. per ½kg 1lb and 25 minsMins. per ½kg 1lb and 15 mins ¼ 2¾ hoursRolls and buns 10 20 mins 30 40 minsBase Well Done Oven cooking chart Second ovenBase Medium Lamb Shelf on Medium½ hours Individual 20 30 mins Cakes Christmas Cake Shelf ½ 4½ hoursBaked custard 50 60 mins Pastries Plate tart shortcrust 25 35 minsFruit pie shortcrust 25 35 mins Baking trayTo use the Countdown Electronic timerTurn the selector knob to Manual then turn to Time Setting To set the time of dayEither direction Setting the controls for automatic useAutomatic control Showing Selector knob to Correct time?Food to be How long will Turn the selector knob to Food takeTo cook? Display What time do Turn the selector knob to You wantHints and tips for automatic cooking Please note There is no slow cook on the second oven Slow cookingFood preparation slow cooking Left over food should be cooled quickly and refrigerated Do not cook casseroles over 2.7kg 6lbCover food with a tight fitting lid or tin foil Thaw thoroughly before cookingCare and cleaning For your safety Crown to body Do not try to force the crown on to the body When replacing hotplate burner partsGrill and oven furniture Main oven Main oven cleaning cycle To remove the outer glass Cleaning between the outer and inner door glassMake sure that a stability bracket is fitted Cleaning The Door GlassInstalling the appliance LocationHeight to hotplate 900mm 920mm Appliance dimensionsPositioning Curtains behind the applianceMoving your appliance General information For your safetyConnecting to the electricity supply Replacing the oven light bulb Check What is wrong and why?Probably a fault 7 0 5 9 2 9 9 2 Service and spare partsCustomer Care Department Installation Instructions Hotplate DimensionsConnections GrillGeneral Important Safety RequirementsMain Oven Second OvenLocation of Appliance Fitting the Stability Bracket Parts RequiredLevelling the Appliance Connection to the Electricity Supply Connecting to GASChecking LID SHUT-OFF Device Pressure TestingChecking the Grill Checking the HotplateAutomatic Operation Checking the Main Oven ControlsChecking the Main Oven General Note Checking the Second OvenChecking the Main Oven Light Contents Check List Telephone 0870 5 Part Number311506205 55 77 High Street

SIG 505 X specifications

The Electrolux SIG 505 X is a modern, high-performance built-in oven designed to enhance your cooking experience. Combining elegance with cutting-edge technology, this oven stands out for its sleek stainless-steel finish, ensuring it complements any contemporary kitchen decor.

One of the main features of the Electrolux SIG 505 X is its multifunction cooking system. This oven offers a wide range of cooking options, including conventional cooking, fan cooking, grilling, and baking, allowing users to experiment with various recipes effortlessly. The fan cooking feature ensures even heat distribution, which results in perfectly cooked dishes every time, whether you're roasting a chicken or baking a batch of cookies.

The SIG 505 X is equipped with intuitive controls, featuring a digital display that makes setting temperatures and cooking modes straightforward. The user-friendly interface includes touch controls, simplifying navigation through the different cooking settings. Additionally, the oven includes a programmable timer to ensure meals are cooked to perfection, while the delay start function allows you to set cooking times in advance.

Another noteworthy characteristic is the oven's pyrolytic self-cleaning function. This innovative technology burns off food residues at high temperatures, leaving the oven clean without the use of chemical cleaners. This not only saves time on cleaning but also ensures a hygienic cooking environment.

The Electrolux SIG 505 X also prioritizes energy efficiency. It is designed to consume less energy while maintaining high cooking performance, adhering to strict energy-saving regulations. This feature not only helps the environment but also reduces energy bills for the homeowner.

In terms of capacity, the SIG 505 X offers a generous interior space, allowing for the preparation of large meals. The oven's shelves can be adjusted to accommodate various cookware sizes, enhancing its versatility for different cooking needs.

Safety features are an essential aspect of the Electrolux SIG 505 X. It includes a child lock function to prevent accidental operation and heat-resistant doors that keep outer surfaces safe to touch, protecting younger family members.

In summary, the Electrolux SIG 505 X is a standout built-in oven that merges sophisticated design with advanced cooking technology, making it an ideal choice for home cooks of all skill levels. Its versatile cooking options, energy efficiency, and self-cleaning capabilities truly make it a valuable addition to any kitchen.
Top Page Image Contents