Electrolux ES510L manual Setting Warming Drawer Controls, To Remove the Warming Drawer

Setting Warming Drawer Controls

Removing & Replacing the Warming Drawer

Fig. 1

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the Warming Drawer.

To Remove and Replace the Warming Drawer (some models)

To Remove the Warming Drawer:

1. Turn power off before removing the Warming Drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Fig.1).

4. Pull the drawer away from the range.

To Replace the Warming Drawer:

1.Pull the bearing glides to the front of the chassis glide (See Fig. 2).

2. Align the glide on each side of the drawer with the glide slots on the range.

3. Push the drawer into the range until levers “click” (approximately 2”). Pull the drawer open again to seat bearing glides into position. If you do not

hear the levers “click” or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warming Drawer will NOT operate while in the Self-Clean and “Oven Lockout” modes.

Fig. 2

9