Electrolux Drop-in, Slide-in manual Adjusting Your Oven Temperature, Storage Drawer some models

Page 25

Care & Cleaning

To Remove and Replace Warmer Drawer (some models)

 

Latch

Left Glide

Pull up latch

with finger

 

Latch

 

Pull down latch

Right Glide

with finger

 

Figure 1

 

To remove Warmer Drawer:

1.Turn power off before removing the warmer drawer.

2.Open the drawer to the fully opened position.

3.Locate the latches on both sides of the warmer drawer.

4.Pull up on the left glide latch and push down on the right glide latch.

5.Pull the drawer away from the range.

6.To clean warmer drawer, gently scour with a soapy scouring pad, this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners or the porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.

To Replace Warmer Drawer:

1.Align the glide latches on both sides of the drawer with the slots on the drawer.

2.Push the drawer back into the range.

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

Storage Drawer with extensible glides (some models)

To remove Warmer Drawer:

1.Open the drawer to the fully opened position.

2.Locate the latches on both sides of the warmer drawer. (See Figure 1)

3.Pull up on the left glide latch and push down on the right glide latch. (See Figure 1)

4.Pull the drawer away from the range.

5.To clean warmer drawer, gently scour with a soapy scouring pad, this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners or the porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.

To Replace Warmer Drawer:

1.Align the glide latches on both sides of the drawer with the slots on the drawer.

2.Push the drawer back into the range.

Storage Drawer (some models)

Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use care when handling the drawer.

Removing and Replacing Storage Drawer

To remove the drawer:

1.Pull empty drawer out to the roller guide stop.

2.Tilt the drawer up and pull it out over the rollers.

To replace the drawer:

1.Insert the rear end of the drawer into the opening.

2.Fit the drawer end rollers onto the guide rails.

3.Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push in.

Storage

Roller Drawer

Roller

Guide

Front

 

Frame

Figure 2

 

Adjusting Your Oven Temperature

For instructions on how to adjust the oven temperature refer to the electronic oven control guide.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Care & Cleaning 18-25 Adjusting Your Before Setting Oven Controls 13-14Warranty Back Cover WelcomeQuestions? Welcome & CongratulationsVersión en español Register Your ProductSLIDE-IN Models only Important Safety InstructionsKnow which knob controls each surface heating unit Important Instructions for Using Your CooktopAvoid scratching the cooktop glass with sharp ob- jects Important Instructions for Using Your OvenBridge Features At a GlanceDual Setting Type of Cooking Setting Surface ControlsModels with Coil Elements About the Ceramic Glass Cooktop Models with Ceramic Glass CooktopAbout the Radiant Surface Elements Locations of the Radiant Surface Elements and ControlsAvailable Esec Display Settings Surface Cooking Settings Models with Ceramic Glass CooktopRecommended Settings for Single, Bridge Electronic Surface Element Control Esec some modelsEsec Error Indicator Message Er Hot Surface Indicator LightsEsec Lockout Feature To Operate the Single Surface ElementsTo Operate the Dual Surface Element Small Element LargeTo Operate the Bridge Surface Element Model a Only Surface cooking Before Setting Oven ControlsSelecting Surface Cooking Cookware Cookware Material typesArranging Oven Racks Setting Oven ControlsOven Vent Location -Models with Ceramic Glass Cooktop Removing and Replacing Oven RacksWarmer Drawer Temperature Selection Setting Warmer Drawer Control If EquippedArranging Warmer Warm & Ready Drawer Rack Positions Operating the Warmer DrawerCooking Informations Baking Problems and Solutions ChartPreheating Broiler Clean-Up TipsTo Broil Determining Broiling TimesCleaning Various Parts of Your Range Care & CleaningSurfaces How to Clean Porcelain enamel Cooktop Cleaning Coil Surface Element Models OnlyCooktop, surface under Cooktop Insert Control PanelCooktop Cleaning Porcelain enamel Cooktop Models Cooktop Cleaning- Coil Surface Element Models OnlyPorcelain enamel cooktop cleaning instructions some models Plastic or foods with a high sugar content Cleaning Recommendations for the Ceramic Glass CooktopFor light to moderate soil For heavy, burned on soilCleaning the Regular Oven non self-clean oven, some models Oven CleaningAluminum utensils Cleaning the Self-Clean Oven some models To Remove the Hidden Bake Cover some models Removing and Replacing the Oven DoorChanging Oven Light To Remove and Replace Warmer Drawer some models Adjusting Your Oven TemperatureStorage Drawer with extensible glides some models Storage Drawer some modelsBefore you call Solutions to Common ProblemsAvoid Transportation Damage to your Range Range Warranty Warranty Information
Top Page Image Contents