Frigidaire 318203825 warranty Models with Ceramic Glass Cooktop, About the Ceramic Glass Cooktop

Setting Surface Controls

Models with Ceramic Glass Cooktop

Model A Model B Model C

About the Ceramic Glass Cooktop

The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element outline on the cooktop (See Fig. 1).

Heat is transferred up through the surface of the cooktop to the cookware. Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and their settings, are all factors that will affect the amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns.

Model DModel E

Cooktop radiant areas that heat. Your appliance may

have one of these configurations - Fig. 1

								Smal l		Large
OFF			OFF		OFF			Petit	OFF	Grand
l o	hi	l o	hi	h	l o	hi		hi		hi
si		si			si
2	8	2	8	me	2		8	6		6
3	7	3	7	l	3		7	4		4
4	6	4	6					2		2
				On/	4	6
med			med		med				l o	l o

Warming

Zone

Zone

Warming

Zone

Warming

Zone

About the Radiant Surface Elements

The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and consistent heat during the off cycle. For efficient cooking, turn off the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.

Locations of the Radiant Surface Elements and Controls

Your range is equipped with radiant surface elements with different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases.

The radiant surface elements are located on the cooktop as follows:

Model A (See Fig. 1):

-Two dual 5 or 7 inch radiant element at the right and left rear position;

-Two dual 6 or 9 inch radiant element at the right and left front position;

Model B (see Fig. 1):

-Two 6 inch radiant elements at the right rear and left front positions;

-A 8 inch radiant element at the left rear position;

-A dual 6 / 9 inch radiant element at the right front position;

Model D shown Only - Fig. 2

NOTE: Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning section and Before You Call checklist section of this Use and Care Guide.

NOTE: Radiant elements have a limiter that allows the element to cycle on and off, even at the HI setting. This helps to prevent damage to the ceramic smooth top. Cycling at the HI setting is normal and can occur if the cookware is too small for the radiant element or if the cookware bottom is not flat (Refer to page 12 under Selecting Surface Cooking Utensils).

NOTE: Due to the high intensity of heat generated by the surface elements, the glass surface will turn green when the element will be turned off.This phenomenon is normal and the glass will come back to its original white color after it has completely cooled down (White glass cooktops only).

Model C (see Fig. 1):

-Two 6 inch radiant elements at the right and left rear positions;

-A dual 9 / 12 inch radiant element at the right front position;

-A 9 inch radiant element located at the left front position.

Model D (See Figs. 1 and 2):

-Two 6 inch radiant elements at the right and left rear positions;

-A dual 9 / 12 inch radiant element at the right front position;

-A 9 inch radiant element located at the left front position;

-A Warmer Zone radiant element located between the right and left rear positions.

Model E (see Fig. 1):

-A 6 inch radiant element at the right rear position;

-A dual 9 / 12 inch radiant element at the right front position;

-A Bridge radiant element located at the left front & rear positions.

8