Setting Surface Controls
Fig. 1
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the element.
To Operate Radiant Surface Elements
1.Place correctly sized cookware on the radiant surface element.
2.Push in & turn the surface control knob in either direction to the desired setting (See Fig.1). Start most cooking operations on a higher setting & then turn to a lower setting to finish cooking. The surface control knobs do not have to be set exactly on a particular mark. Use the marks as a guide & adjust the control knob as needed. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.
3.When cooking is completed, turn the surface element OFF before removing the cookware. Note: the Element ON indicator light will glow when one or more elements are turned ON. A quick glance at the indicator light(s) when cooking is finished is an easy check to be sure all control knobs are turned OFF. The Hot Surface indicator light will continue to glow AFTER the control knob is turned to the OFF position & will glow until the heating surface area has cooled sufficiently.
Suggested Surface Control Settings
The suggested settings found in the chart below are based on cooking in medium- weight metal pans with lids. Settings may vary when using other types of pans. Note: The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.
Surface Control Settings
Setting | Type of Cooking |
HIGH (HI - 9) | Start most foods, bring water to a boil, pan broiling |
|
|
MEDIUM HIGH (7 - 8) | Continue a rapid boil, fry, deep fat fry |
|
|
MEDIUM (5 - 6) | Maintain a slow boil, thicken sauces & gravies, steam |
| vegetables |
|
|
MEDIUM LOW (2 - 4) | Keep foods cooking, poach, stew |
|
|
LOW (LO - 1) | Keep warm, melt, simmer. |
|
|
Setting Oven Controls
Note: The time of day must first be set in order to operate the oven.
To Set or Change the Temperature for Baking
The oven can be programmed to bake at any temperature from 170°F to 500°F.
To Set the Controls for Baking:
1.Press 
. "— —
2.Within 5 seconds, press the 
or 
. The display
will show "350°F." By pressing and holding the 
or
, the temperature can then be adjusted in 5°F increments.
3.When the 
or 
is released, the oven will begin
heating to the selected temperature. When the displayed temperature reaches the desired baking temperature, the control will beep once (1 time).
4. To cancel the baking function, press 
.
To Change the Oven Temperature after Baking has Started:
1. | Press | and make sure the bake temperature is | |
| displayed. |
|
|
2. | Press the | or | to increase or decrease the set |
6 | temperature. |
|