CDA RV 701 SS manual Connection to Fixed Wiring

Page 40

40

Connection to Fixed Wiring

A double pole switch must be provided no further than 2 metres from the appliance to the electrical supply.

The appliance should be connected to a DOUBLE POLE SWITCHED FUSED SPUR OUTLET, similar to that shown in Fig. 47.

DOUBLE POLE SWITCHED

FUSED SPUR OUTLET

FUSE ON

Use a suitable FUSE in accordance with the appliance power rating.

Fig. 47

We recommend that the appliance is connected by a suitably qualified person who will comply with the IEE and local regulation.

Image 40

Contents

RV 701 SS Dual Fuel Cooker Appliance Information Declaration of CE ConformityGas Burners Features and Technical DataConventional Oven Fan Oven Controls Description Control PanelPilot lamps Illuminated Symbols Clock and Timer with Touch-Control KeysKeys Setting the Clock Using the TimerSetting the Timer Volume Touch-Control KeysAutomatic Cooking Hob Burners How to Use the Hob BurnersLighting of the Hob Burners Correct Use of Triple Ring Burner Choice of BurnerBurner Size General Features How to Use the Fan Oven Bottom Main OvenOperating Principles Switch and the Temperature Selector Cooking Advice By normal convection How to Use the Convection Oven Top OvenBy radiation Thermostat Knob fig Function Selector Knob figOven Light Traditional ConvectionLower Heating element Upper HeatingGrilling Use of the GrillDo’s and do not’s For Your Safety Important NotesCare and Maintenance Cleaning the HobFlexible Tube Gas TapsGlass Control Panel Burners and Grids Correct Position of Triple Ring Burner Assembling and Dismantling of the Side Runner Frames Inside of Oven Replacing the Halogen Oven LightTop Oven Door Removing the Oven DoorCleaning the Panes of Glass Removing the Inner Pane of GlassReplacing the Inner Pane of Glass Check that the four rubber pads are in place D in FigBottom Oven Door Replacing the Inner Pane of Glass For the Installer Location200 mm It is mandatory to install the backguard BackguardPage Provision for Ventilation Installation and Service Regulations United Kingdom Gas InstallationImportant Note Installation to Natural Gas Installation to LP Gas Gas Connection Do not use a naked flame to test for leaks Gas Connection Cat II 2H3+Injectors Replacement of Top Burners Adjusting of the Minimum of the Top BurnersConversion to Natural Gas or to LPG Normally for LPG, tighten up the regulation screwLubrication of the Gas Taps BurnersElectrical Installation Electrical Feeder Cable ConnectionFeeder Cable Section This appliance must be earthedConnection to Fixed Wiring Appliance Servicing Contact telephone numbersGuarantee Limit of CoverPage Cod ß2