Frigidaire 316257114 manual To Raise the Top for Cleaning for Coil Cooktop models only

			Care & Cleaning
		To Raise the Top for Cleaning (for Coil Cooktop models only)
	When lowering the lift-up
		1.	Grasp the sides and lift from the front. Lift-up rods will support the top in a
range top, grasp the sides with finger-
			raised position. Only lift the top far enough to allow the support rods to snap
tips only. Be careful not to pinch fingers.
			into place.
DO NOT drop or bend the range top
		2.	Clean underneath using a clean cloth and hot, soapy water.
when raising or lowering. This could
		3.	To lower the top, gently push back on each rod to release the notched support.
damage the surface.
			Hold the range top and slide the lift rods down into the range frame.

Changing the Oven Light (some models)

On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven.

To replace the oven light:

1. Turn electrical power off at the main source or unplug the range.

2. Replace bulb with a new 40 watt appliance bulb.

3. Turn power back on again at the main source (or plug the range back in).

4. The clock will then need to be reset. To reset, see Setting Oven Controls in this Use & Care Manual.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

To Remove and Replace Oven Door

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3. Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4. To clean oven door, follow the instructions provided in the Care & Cleaning table.

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2. Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

3.Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the bottom corners of the door as far as they can go.

4.If the door is not in line with the oven frame, remove it and repeat the above steps.

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

15