DeLonghi DEGLSC 24 SS Levelling the Range, ANTI-TIP Stability Device Installation Instructions

Page 7

LEVELLING THE RANGE

The range is equipped with 4 LEVELLING FEET (supplied in a separate kit) and may be levelled by screwing or unscrewing the feet (fig. 1.8).

It is important to observe the directions of figures 1.6, 1.7a, 1.7b.

Fig. 1.6

Supplied with the range in a separate kit

0 mm 0"

+5/16"

+8 mm

Fig. 1.7a

YOU MUST USE STABILITY

ANTI TIP BRACKET TO

PREVENT UNIT FROM

TIPPING.

Supplied with the range in a separate kit

+ 5/16" + 8 mm

+ 11/16"

Fig. 1.7b

+ 17.5 mm

Fig. 1.8

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1.The anti-tip bracket has to be attached as shown on figure below (only rear right side), it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws (not supplied).

2.After fixing the anti-tip bracket, slide range into place. Be sure the rear right foot slides under the anti-tip bracket attached.

Dotted line showing the position of the range when installed

=

ANTI-TIP STABILITY

DEVICE FIXING

=

(223

8"

25/32

mm)

Anti-tip stability

Rear right device feet of range

Fig. 1.9

7

Image 7
Contents Electric Range ALL Ranges can TIP Installation Instructions Electrical Grounding Instructions Replacement PartsElectric Connection Proximity to Side CabinetsAssembling the Backguard It is mandatory to install the backguardLevelling the Range ANTI-TIP Stability Device Installation InstructionsElectrical Requirements Electrical Connection with Power CordElectrical Connection with Conduit Wire Flat Power Cord Installation Wire Power Cord Installation Wire Conduit Installation 120 Wiring DiagramPage Page Page Cod ß3