Sherwood RX-4100 manual Adjusting the tonebass and treble, Adjusting the sound volume balance

Adjusting the tone(bass and treble)

Enter the tone mode.

8	POWER		A SPEAKER B
	51	62	73	84
TONE	9	0	FM MODE MEMORY
	DISPLAY	SLEEP	P.SCAN	TUNER
	CD	TAPE	VCR	AUX
	AUDIO CONTROL		TONE SEL

or	BALANCEMUTE VOLUME	TONE SEL
	REMOTE CONTROL UNIT RM-101

Each time this button is pressed, the corresponding tone mode is selected and shown for 5 seconds as follows:

BAS(s) TRE(ble)

Note:

When the tone direct function is activated, the tone mode cannot be entered and “T-DIR” is displayed.

At the desired tone mode, adjust the tone as

9 desired.

		POWER		A SPEAKER B
		1	2	3	4
		5	6	7	8
		9	0	FM MODE MEMORY
		DISPLAY	SLEEP P.SCAN		TUNER
		CD	TAPE	VCR	AUX
or	TREBLE	AUDIO CONTROL		TONE SEL
		BALANCE		MUTE	VOLUME
	/BASS

REMOTE CONTROL UNIT RM-101

If the tone display disappears, start from the step 8 again.

Notes:

Extreme settings at high volume may damage your speakers.

In general, the bass and treble levels are adjusted to 0.

ENGLISH

To listen to a program source without the tone effect.

TONE DIRECT	“T-DIR” is displayed and the sound that bypasses
	the tone circuitry will be heard.
	To cancel the tone direct function, press this button
	again to display “D-OFF”.

Adjusting the sound volume balance

Enter the balance mode.

BALANCE

“BAL” is displayed for 5 seconds.

Adjust the sound volume balance between the left and right speakers.

		POWER		A SPEAKER B
		1	2	3	4
		5	6	7	8
		9	0	FM MODE MEMORY
		DISPLAY	SLEEP	P.SCAN	TUNER
		CD	TAPE	VCR	AUX
or		AUDIO CONTROL		TONE SEL
	BALANCE	BALANCE		MUTE	VOLUME

REMOTE CONTROL UNIT RM-101

If the balance display disappears, start from the step 11 again.

When the BALANCE + / - buttons on the remote control are pressed, it enters the balance mode automatically without pressing the BALANCE button on the front panel.

Note:

In general, the balance level is set to the center position(red dot).

1 1