GE JS998TKWW, JSS26, JS998BKBB dimensions JS998TK/BK

JS998TK/BK

GE Profile™ 30" Slide-In Electric Range with Trivection™ Technology

24

Accessory

Backguard

31-1/4 30 A/B*

Dimensions and Installation Information (in inches)

		Note: Cabinets installed adjacent to slide-in ranges must have an adhesion
KW Rating
		spec of at least 194° temperature rating.
240V	12.8	Note: 30" ranges conform to U.L. requirements for 0" spacing from adjacent
208V	8.7	walls below countertops. To reduce possibility of scorching walls, engineering
		recommends a minimum of 1-1/2" spacing to allow for possible extended,
Breaker Size
		high-heat, no-load heating element operation.
240V	40 Amps	Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible
208V	40 Amps	service cord or conduit must be used because terminals are not accessible
		after range installation. See shaded area in drawing for location of electrical

outlet box. Recommended outlet locations allow range to be installed directly against rear wall.

2-7/8" To Front Surface Of Countertop

20-5/8" Door

Clearance

From Front

Surface of

Countertop

36-1/4

Optional Kits For Slide-In Electric Ranges

(Available At Additional Cost)

Accessory Backguards (Attaches to the back of range as a backguard when unit is installed in 30" free-standing cutout)

JXS32SS (Stainless) - 4" High JXS32WW (White) - 4" High JXS32CC (Bisque) - 4" High JXS32BB (Black) - 4" High

JXS37WW (White) - 5-1/4" High

JXS37CC (Bisque) - 5-1/4" High

JXS37BB (Black) - 5-1/4" High

Body Sides

(Slide-in ranges are sold without sides installed. Can be installed on either left or right when unit has one exposed side [no cabinet adjacent]. Kit contains

1 body side) JXS77WW (White) JXS77CC (Bisque) JXS77BB (Black)

Vertical Side Trim Kits

(If cabinet cutout width is more than 30", a vertical side trim kit may be used to close the gap between the range and cabinet) JXS86WW (White)

JXS86CC (Bisque)

JXS86BB (Black)

Optional Lower Trim Kits (If counter height is greater than 36.5", a lower trim kit is recommended to extend the useful height to 38" maximum)

JXS56WW – White

JXS56CC – Bisque

JXS56BB – Black

Optional Top Filler Kits JXS66WW – White JXS66CC – Bisque JXS66BB – Black

If you are NOT using the Filler strip or Backguard:

23-3/16

30

If you are using the Filler strip or Backguard:

25

Recommended

6" Min.

From Walls

35-7/8"–38"

25-3/4**	*JXS37 is 5-1
(excluding handle)	**Total depth f
	front of clos

	Shave Raised Edge To Clear
30" Min.	31-1/8" Wide Control Panel
	Excluding Models JSS28 and JSP39
	9/16
30" Min.
23-3/16	Acceptable
	Electrical	13" Max.
	Outlet Area	15" Min.

25

Installation information: Before installing, consult installation instructions packed with product for current dimensional data.

30

from floor to countertop

2-1/2

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

30

7-1/2

2-1/2

All GE ranges are equipped with an Anti-Tip device. The installation of this device is an important, required step in the installation of the range.

Listed by Underwriters Laboratories

Specification Revised 1/08 220452