GE JR JGSP22 A number or, Display flashes, Unable to get, Display to show SF, Power outage, Vent

Page 30

Customer Service Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Before you call for service…

Troubleshooting Tips

Problem		Possible Causes		What To Do

“F— and a number or		You have a function error code.		• Press the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display				one hour. Put the oven back into operation.

		If the function code repeats.		• Disconnect all power to the range for at least 30
				seconds and then reconnect power. If the function
				error code repeats, call for service.

Display flashes		Power failure.		• Reset the clock.

Unable to get the		Oven control pads were		• The BAKE and BROIL HI/LO pads must be pressed
display to show “SF”		not pressed properly.		at the same time and held for 3 seconds.

Power outage,		Power outage or surge.		• Reset the clock. If the oven was in use, you must reset
clock flashes				it by pressing the CLEAR/OFF pad, setting the clock
				and resetting any cooking function.

“Burning” or “oily”		This is normal in a new oven		• To speed the process, set a self-clean cycle for a
odor emitting from		and will disappear in time.		minimum of 3 hours. See the Using the self-
the vent				cleaning oven section.

Strong odor		An odor from the insulation		• This is temporary.
		around the inside of the oven
		is normal for the first few times
		the oven is used.

		Improper air/gas ratio in		• Call for service.
		the oven.

Fan noise		A cooling fan may		• This is normal. The cooling fan will turn off and on.
		automatically turn on and
		off to cool internal parts.

30

Image 30

Contents RangesGas Slide-In ANTI-TIP Device Removing Packing MaterialsService Partnership For Your RecordsImportant Safety Notice Safety PrecautionsCustomer Service Safety Instructions Surface Burners SELF-CLEANING Oven Cook Meat and Poultry THOROUGHLY…Oven Flooring Under the Range Service TroubleshootingConversion Leveling the RangeUsing the surface burners SafetyTips Customer Service Using the oven controls Oven Control, Clock and Timer Features and SettingsCare and Cleaning Troubleshooting Tips Customer Service Special features of your oven controlFahrenheit or Centigrade Temperature Selection Hour Shut-OffTones at the End of a Timed Cycle Hour, 24 Hour or Clock Black-OutYour control is set to use a 12 hour clock Safety Instructions Operating Cook and HoldChanging the Speed of the Increase or Decrease Pads Customer Service Troubleshooting Using the ovenCleaning Operating InstructionsCleaning Troubleshooting TipsInstructions Operating HI Broil How to Set the Oven for BroilingBroiling Guide Broil HI/LO pad againUsing the clock and timer Troubleshooting Tips Customer ServiceCare and Cleaning Using the timed baking and roasting featuresSafety Instructions Customer Service Troubleshooting TipsAdjust the oven thermostat-Do it yourself To Adjust the ThermostatType of margarine will affect baking performance Using the self-cleaning oven Before a Clean CycleCare and Cleaning Troubleshooting Tips Customer Service After a Clean CycleHow to Remove Packaging Tape Care and cleaning of the rangeCustomer Service Troubleshooting Tips Care Burner AssemblyBurner Grates Safety Instructions OperatingService Porcelain Enamel Cooktop on some modelsLift-Off Oven Door Removable Storage DrawerPainted Surfaces Broiler Pan & Grid Oven Light BulbRemovable Oven Bottom Anti-Tip Device Operating Instructions SafetyService Troubleshooting Tips Care Control Panel Before you call for service… Oven temperature too Clock and timerSee the Using the clock and timer section See the Adjust the oven thermostat-Do it yourselfClean cycle See the Using the self-cleaning oven sectionAfter a clean cycle Oven not clean after a Is on when you wantDisplay flashes Power outageA number or Unable to getGas Range Warranty Cleaning Troubleshooting Tips Customer ServiceService Telephone Numbers Special Needs Service In the U.S