Installation Instructions
3POWER CORD AND
STRAIN RELIEF INSTALLATION
ARemove the wire cover (on the back of the range) by removing five (5) screws using a 1/4” nut driver.
Do not discard these screws.
5 screws to remove wire cover
Retaining 
tabs 
Back of range
Wire cover
BRemove the knockout ring (13⁄8″) located on bracket directly below the terminal block. To remove the knockout, use a pair of pliers to bend the knockout ring away from the bracket and twist until ring is removed.
Terminal block (appearance may vary)
Knockout
Knockout ringring removed in bracket
5
CFor power cord installations only (see the next step if using conduit), assemble the strain relief in the hole. Insert the power cord through the strain relief and tighten. Allow enough slack to easily attach the cord terminals to the terminal block. If tabs are present at the end of the winged strain relief, they can be removed for better fit.
NOTE: Do not install the power cord without a strain relief. The strain relief bracket should be installed before reinstalling the rear range wiring cover.
Terminal block
Strain relief
Power cord Bracket
Skip to Step 4 or 5.
DFor conduit installations only, purchase a squeeze connector matching the diameter of your conduit and assemble it in the hole. Insert the conduit through the squeeze connector and tighten. Allow enough slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze connector. The squeeze connector should be installed before reinstalling the rear range wiring cover.
Terminal 
block
Squeeze
connector
Conduit | Bracket |
Skip to Step 6 or 7.