GE JGBC16GEJ Range Top Burners, Control F%mels, Outer Enamel Finish, To remove the glass panel

._+4.--” - .- - -

0 Range Top Burners

The holes in the burners must be kept clean at all times for proper ignition and an even, unhampered flame,

Clean the burners routinely and especially after bad spillovers which could clog these holes. Burners lift out for cleaning.

Note: Two screws hold each burner pair in place to keep them from wobbling around during shipment.

~ Remove and discard the shipping

Control F%mels

It’s a good idea to wipe the control panels clean after each use of the oven, For a more thorough cleaning, the control knobs can be pui.led off- the knob stems and, on models so

equipp@ tie glass upper control panel can be cleaned on both sides.

B=-

To remove the glass panel:

1. Remove the screw on each end of

the backsplash.

2. Remove the metal strips on each

end that hold the glass in place.

3. Remove the clock knob and nut

securing the light switch.

4. Carefidly remove the glass and

Outer Enamel Finish

When the range is cool, wash the enarnel finish with mild soap and water or a mild abrasive cleanser applied with a damp cloth. Rinse with clean water and dry with a soft cloth. If you wish, occasionally apply a thin coat of mild cleaning wax to help protect the finish.

To avoid marring the surface of the range and to prevent it from becoming dull, don’t slide heavy pans across it. If you spill fds with a lot of acid or high sugar content, clean them up as soon as possible. If allowed to remain, these fds could cause a dull spot. Also, never use harsh abrasive cleansers. They could permanently damage the enamel surface.

@

crews and lift the burners up and

place it on a smooth, flat surface.

out. This disengages them from the mounting bracket under each burner pair.

To remove burned-on food, soak the burner in a solution of a product used for cleaning the inside of coffee makers. Soak the burner for 20 to 30 minutes. If the food doesn’t rinse off completely, scrub it with soap and water or a mild abrasive cleanser and a damp cloth.

Do not attempt to clean burners in an automatic dishwasher. Loosened food soil can clog burner holes, and the caustic action of the dishwasher detergent can damage the burner heads.

Before putting the burner back, dry it thoroughly by setting it in a warm oven for 30 minutes. Then place it back in the range, making sure it is properly seated on the mounting bracket and is level.

Clean it with miid soap and water,

rinse with clean water and dry with

a soft cloth. Caution: Do not use

abrasive cleansers, strong liquid

cleaners or oven cleaners. on glass or

enamel control panel surfaces—they

will darnage the finish.

-’