GE ZGG48L31, ZGG48N31 Questions? Use this problem solver Problem Solver, Igniter is Turned

Page 27

Questions?

Use this problem solver!

		The Problem Solver

		Stainless Steel Outdoor Cooking Center

	PROBLEM	POSSIBLE CAUSE

	GRILL WON’T LIGHT	• Check to see if other burners on the unit operate.
	WHEN THE ROTARY	• Remove the grill rack and the stainless steel radiant tray, and watch
	IGNITER IS TURNED
	IGNITER IS TURNED	the igniter tip. You should see a spark jump from the tip of the

		igniter when the knob is turned. If there is a spark, then check to
		ensure there is gas supplied to the unit.
		• Use a match to light the burner. (See the “To light the grill” section).
		• Visually check the electrode and wire while turning the igniter.
		The only place a spark should appear is at the electrode tip.
		If the electrode or wire leaks voltage, remove and replace.
		• Purge the gas line of any air.
		• Check the brass orifice for blockage.
		• Inspect the igniter tip to make sure it is clean and free from debris.
		Clean the area. Readjust for 1/8″ gap.

	BURNER FLAME IS	• Check the burner inlet for obstructions.
	YELLOW OR ORANGE	• Check the air shutter for proper adjustment.
	IN CONJUNCTION	(See the “Installation Instructions”).
	WITH THE ODOR	(See the “Installation Instructions”).
	WITH THE ODOR	• Placement of the cooking center is important for proper burner
	OF GAS
	OF GAS	operation. Do not place the cooking center in a dusty area.
		operation. Do not place the cooking center in a dusty area.

	LOW HEAT WITH	• Inspect the fuel hose to ensure it is not bent or kinked.
	CONTROL KNOB IN	• Adequate gas supply may not be available. Check to make sure there
	THE HI POSITION
	THE HI POSITION	is gas in the LP tank (if included).
		is gas in the LP tank (if included).
		• If it is only one burner that appears low, the burner or burner orifice
		may need cleaning.
		• The air shutter may need adjustment.
		• Preheat the grill for 15 minutes with the lid closed.

	ROTISSERIE BURNER	• Check for a spark at the igniter.
	WON’T LIGHT	• Use a match to light the burner.
	(on some models)	• Use a match to light the burner.
	(on some models)

	OPTIONAL	• Readjust the thermocouple so that it is not bent or kinked, but
	ROTISSERIE LIGHTS	lies flat against the burner.
	BUT WILL NOT HOLD	• Hold the safety valve button in until the burner remains lit.
	FLAME ONCE
	BUTTON IS RELEASED
	(on some models)

	THE GRILL BURNER	• The burner may be upside down. Rotate the burner 180° and
	WILL NOT SIT LEVEL	reinstall. Make sure it is secure and level.
	INSIDE THE GRILL
	BOX

27

Image 27

Contents Ge.com Contents For Your Safety Safety PrecautionsIf you received a damaged cooking center Before using your cooking centerIf you need service Write down the model Serial numbersImportant Safety Instructions Important Safety NoticePay close attention when lighting a burner Unattended in an area where the cookingFor personal safety, wear proper apparel Use a pot holder when opening the roll topSafety Precautions Design information Features of Your Cooking CenterGrill General informationGourmet Radiant Trays Do not use the grill if the odor of gas is present Lava rockCeramic briquettes Before lighting the grillEach grill burner has its own rotary igniter To light the grillRemarque Allumage du grilUsing the grill Grilling hintsDo not leave the grill unattended while cooking Fresh Vegetables Grilling guideFlame height Range-top burnersRange-Top Burners To light a range-top burnerRotisserie system Rotisserie SystemAssembly To setup the grill for rotisserie Basting panTo load the skewer To light the rotisserie burner Cooking timesWait 5 minutes before relighting a hot rotisserie burner Smoker System Smoke flavor trayWood chips Smoker System To lightSmoker burner Care and Cleaning Drip traysLava rocks Burner grates Burner removal Care and CleaningReplacing Rotary igniter Spider and insect warningNot rock Rotisserie Burner cleaningOrifice cleaning Control panel and knobs Stainless steel surfacesIgniter is Turned Questions? Use this problem solver Problem SolverService Consumer ServicesRegistration Ownership Product Consumer Consumer Product Ownership Registration Warrantor Camco, Inc., Burlington, Ontario Warranty for customers in CanadaWarrantor General Electric Company, Louisville, KY Warranty for customers in the USA