Maytag W10289536A installation instructions Bare Wire Torque Specifications, Wire Awg Torque

4.Attach terminal lugs to line 1 (black), neutral (white), and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to

XX lbs-in. torque. See Bare Wire Torque Specifications chart.

A

B

C D E

A. Terminal lug

B.Setscrew

C.Line 1 (black) wire

D.Neutral (white) wire

E.Line 2 (red) wire

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

Wire Awg	Torque
8 gauge copper	25 lbs-in. (2.8 N-m)
6 gauge aluminum	35 lbs-in. (4.0 N-m)

5.Use Phillips screwdriver to connect the bare (green) ground wire to the range with the ground-link screw. The ground wire must be attached first and must not contact any other terminal.

6.Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts.

3-wire connection: Direct Wire

Use this method only if local codes permit connecting ground conductor to neutral supply wire.

1.Pull the conduit through the hole and conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block.

A

B

		C
		D
F	E
A. Terminal block	D. Line 2	(red) wire
B. Ground-link screw	E. Bare (green) ground wire
C. Cord/conduit plate	F. Line 1	(black) wire

2.Attach terminal lugs to line 1 (black), bare (green) ground, and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to

XX lbs-in. torque. See Bare Wire Torque Specifications chart.

A

A

G

B

B
	F
D	E
C

A. 10–32 hex nut	E. Neutral (white) wire
B. Line 1 (black)	F. Line 2 (red)
C. Bare (green) ground wire	G. Terminal lug
D. Ground-link screw

C D E

A. Terminal lug

B.Setscrew

C.Line 1 (black) wire

D.Bare (green) ground wire

E.Line 2 (red) wire

7.Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts.

8.Securely tighten hex nuts.

9.Replace terminal block access cover.

12