Maytag T1 Surface Indicator Lights, Hot Surface Lights, Coil Elements, Lift-upPorcelain Cooktop

Surface Cooking (continued)..............................

Surface Indicator Lights

There is an indicator light under each pair of control knobs. When one or both of the surface control knobs is turned on,

the light will turn on. The light will turn off when the surface element(s) is turned off.

Hot Surface Lights

(glass-ceramic cooking surface

models only)
Each element has a hot /			....	__
surface indicator	f		_'o_Ugoo_:roP "_'_,_I
light. A light will be _			/	//_
illuminated when	the	_"'-_		J/
matching surface	element	is	__
hot. It will remain on, even after the				_

control is turned off, until the area has

cooled. They are located at the front center of the cooktop,

Coil Elements

•When an element is turned on, it will cycle on and off to maintain the heat setting.

•Coil elements are self-cleaning.

•Do not immerse in water.

To remove: When cool, raise element. Carefully pull out

and away from receptacle.

j__,,

To replace: Insert terminals on the element into receptacle. Guide the element into place. Gently press down on the outer edge of the element until it sits level on the drip bowl.

Coil Element Surface

(select models)

i ;:i!

TERMINALS

Lift-upPorcelain Cooktop

To prevent the cooktop from discoloring or staining:

•Clean cooktop after each use.

•Wipe acid or sugar spills as soon as the cooktop has cooled as these spills may discolor or etch the porcelain,

Drip Bowls

The drip bowls, located under each surface element, are designed to catch boilovers and must always be used. Ab- sence of these bowls during cooking may damage wiring or other parts underneath the cooktop.

ii :;Z!i

Your range features an upswept porcelain cooktop that can be lifted up for convenient access to the area under the cooktop,

To prevent the risk of electric shock or fire, never line drip bowls with aluminum foil.

To lift eooktop: When cool, grasp the front edge of the

cooktop. Gently lift up until the two support rods at the front

..... of the cooktop snap into place.

Drip bowls will discolor or craze over time, if overheated. This discoloration or crazing is permanent. However, it will not affect cooking performance.

\	///_	*		TOprotect drip bowl finish:
: ::				,	Avoid using high heat settings for long periods of time.
......				•	Do not use oversized cookware.	Pans should not
',		,_	SUPPORTROD		extend more than 1-2 inches beyond the element.
	_2		I\
				•	When home canning, use the Canning Element (Model
To lower eooktop:	Hold the front edge of the cooktop and				CE1). Contact your Maytag dealer for details.
carefully push back	on each support	rod to release. Then		•	Clean frequently. (See cleaning	section, page 17.)
gently lower the top into place. The support rods will slide

into the range frame.

!! iiSi;

9