Maytag T2 warranty Before You Call For Service

Page 26

Before You Call For Service (continued)

Oven smokes

excessively during

broiling.

Oven will not

self-clean.

Oven did not clean

properly.

Oven door will not

unlock after

self-clean cycle.

Moisture condensation collects on oven window.

There is a strong odor or light smoke when oven is turned on.

A fan sound can be

heard (select models).

“F” plus a number appears in display.

•Food too close to flame. See page 15 for more information.

•Broiler insert covered with aluminum foil.

•Excess fat not trimmed from meat prior to broiling.

•A soiled broiler pan was used.

•Check to make sure controls are properly set.

•Check to make sure the cycle is not set for a delayed start.

•Check if door is closed.

•Longer cleaning time may be needed.

•Excessive spillovers, especially sugary and or acid foods, were not removed prior to the self-clean cycle.

•Oven interior is still hot. Allow about one hour for the oven to cool after the completion of a self-clean cycle. The door can be opened when the LOCK indicator word is not displayed.

•This is normal when cooking food high in moisture.

•Excessive moisture was used when cleaning the window.

•This is normal for a new range and will disappear after a few uses. Initiating a clean cycle will “burn off” the smells more quickly.

•Excessive food soils on the oven bottom. Use a self-clean cycle.

•This is the cooling fan and is normal. The fan will continue to run after use until the oven cools.

•This is called a fault code. If a fault code appears in the display and beeps sound, press the CANCEL pad. If the fault code and beeps continue, disconnect power to the appliance. Wait a few minutes, then reconnect power. If fault code and beeps still continue, disconnect power to the appliance and call an authorized servicer.

•If the oven is heavily soiled, excessive flare-ups may result in a fault code during a clean cycle. Press CANCEL pad and allow the oven to cool for one hour, then reset the clean cycle. If the fault code and beeps still continue, disconnect power to the appliance and call an authorized servicer.

25

Page 25 Page 27
Image 26
Page 25 Page 27
Contents GAS Range Models T2 Read and follow all instructions before using this ap WelcomeTo Prevent Fire or Smoke Damage Child SafetyGeneral Instructions Case of FireUtensil Safety Important Safety InstructionsCooking Safety About Your ApplianceImportant Safety Notice and Warning Cleaning SafetySelf-Clean Oven Controls at a Glance Function PadsTo cancel Setting the ClockSetting the Timer Cook Time /STOP Time PadsAutomatic Oven Turn Off/Sabbath Mode Option Timer Beep OptionsCancel Clock Display Option Control OptionsOven Temperature Adjustment Option To adjust the oven temperatureSurface Cooking Surface ControlsBurner Grates CooktopSealed Burners Oven Fans Oven OperationEven Heat Assist Convection cooking available on select models onlyBaking Chart Cooking Chart for Convenience FoodsOven Bottom Oven VentOven Light Do not place aluminum foil directly on the oven bottomRack Positions Oven RacksHalf Rack Even Heat Assist select models Setting the Controls for BroilingBroiling Clock Controlled Oven Cooking To Start Immediately and Turn Off AutomaticallyBefore Self-Cleaning Care and CleaningSelf-Clean Oven Setting the Controls for Self-CleanAfter Self-Cleaning To Cancel Self-Clean CycleBurner Caps Sealed Gas Burners Care & CleaningBroiler Pan Insert Control KnobsMetal Finishes Drip Pans, porcelain Enamel, paintedGlass Oven Interior Oven Racks Plastic FinishesOven Door MaintenanceCleaning Products Oven WindowOven Bottom Oven LightStorage Drawer Electrical Connection How to Remove Range For Cleaning and ServicingLeveling Legs Before You Call For Service Check these points ifBefore You Call For Service If You Need Service Limited Warranties Parts Only What is Not Covered By These WarrantiesFull One Year Warranty Parts and Labor Canadian Residents
Top Page Image Contents