Wire Power Cord Installation | Avanti ER2403CB, ER2003CB, ER2001G

Cut Ground Strap

Terminal Block Neutral Wire Power Wires Power Cord

Bracket

3-Wire Power Cord Installation

	• Remove the Terminal Block Access Plate on the back
	of range by removing the 2 fixing screws.	Screws
	• Assemble the strain relief in the hole on bracket.	Screws
	• Assemble the strain relief in the hole on bracket.
	• Insert the power cord through the strain relief and
	tighten.
	• Allow enough slack to easily attach the cord terminals
	to the terminal block.
	• Remove the 3 wire terminal nuts and washers from	Terminal Block
	the terminal block.	Terminal Block
	the terminal block.	Access Plate

•Plug the terminal holes of power cord. The neutral or

ground wire of the power cord must be connected to the neutral terminal located in the center of terminal block. The power leads must be connected to the outside terminals.

• Plug washers and tighten nuts securely.

• Assemble the Terminal Block Access Plate.

4-Wire Power Cord Installation

•Remove the Terminal Block Access Plate on the back

of range by removing the 2 fixing screws.	Cut Ground Strap	Grounding Screw
• Assemble the strain relief in the hole on bracket.	Terminal Block
• Insert the power cord through the strain relief and	Neutral Wire
• Insert the power cord through the strain relief and
tighten.	Grounding Wire
• Allow enough slack to easily attach the cord terminals	Power Wires
to the terminal block.	Power Cord
• Remove the 3 wire terminal nuts and washers from	Power Cord
• Remove the 3 wire terminal nuts and washers from	Bracket
the terminal block.	Bracket
the terminal block.

•Remove the ground strap from the frame of range and terminal by removing its screw and cutting is as shown.

•Plug the terminal holes of power cord. The neutral wire of the power cord must be connected to the neutral terminal located in the center of terminal block. The ground wire of the power supply cord must be attached to the frame of range by using the green colored grounding screw. The power leads must be connected to the outside terminals.

•Plug washers and tighten nuts securely.

•Assemble the Terminal Block Access Plate.

←LEVELING THE RANGE

The range must be level to obtain proper operating. The four screws type leveling legs located on the corners at the bottom of range should be adjusted by turning them clockwise to make the range higher or counter-clockwise to lower the range until the range is level. Use a level on surface units to check the leveling of the range.