Avanti ER2402CSS, ER2002CSS manual Wire Power Cord Installation,  Leveling the Range

3-Wire Power Cord Installation

• Remove the Terminal Block Access Plate on the back
	of range by removing the 2 fixing screws.			Screws
• Assemble the strain relief in the hole on bracket.
• Insert the		power	cord through the strain relief and	Grounding Screw
	tighten.	Cut Ground Strap
•		Terminal Block
	Allow enough slack to easily attach the cord terminals
	to the terminal block.
			Neutral Wire
•	Remove the 3 wire terminal nuts and washers from			Terminal Block
	the terminal block.
				Access Plate
		Grounding Wire
• Plug the terminal holes of power cord. The neutral or
	ground wire of the power cord must be connected to
			Power Wires
	the neutral terminal located in the center of terminal			Cut Ground Strap
	block. The power leads must be connected to the
	outside terminals.		Power Cord	Terminal Block
• Plug washers and tighten nuts securely.
			Bracket
• Assemble the Terminal Block Access Plate.				Neutral Wire
				Power Wires
				Power Cord
				Bracket

4-Wire Power Cord Installation

•Remove the Terminal Block Access Plate on the back

of range by removing the 2 fixing screws.	Cut Ground Strap	Grounding Screw
• Assemble the strain relief in the hole on bracket.	Terminal Block
• Insert the power cord through the strain relief and	Neutral Wire
tighten.	Grounding Wire
• Allow enough slack to easily attach the cord terminals	Power Wires
to the terminal block.	Power Cord
• Remove the 3 wire terminal nuts and washers from
	Bracket
the terminal block.

•Remove the ground strap from the frame of range and terminal by removing its screw and cutting is as shown.

•Plug the terminal holes of power cord. The neutral wire of the power cord must be connected to the neutral terminal located in the center of terminal block. The ground wire of the power supply cord must be attached to the frame of range by using the green colored grounding screw. The power leads must be connected to the outside terminals.

•Plug washers and tighten nuts securely.

•Assemble the Terminal Block Access Plate.

LEVELING THE RANGE

The range must be level to obtain proper operating. The four screws type leveling legs located on the corners at the bottom of range should be adjusted by turning them clockwise to make the range higher or counter-clockwise to lower the range until the range is level. Use a level on surface units to check the leveling of the range.

14