Broan QS342SS warranty Teflon-coated bottom cover from hood, Damper/Duct, Connector, Electrical

ALLURE® QS3 SERIES RANGE HOOD

PREPARE THE HOOD

Page 3

PREPARE THE HOOD

3 Remove

Teflon®-coated bottom cover from hood.

Set cover and mounting screws aside.

Teflon® is a registered trademark of DuPont.

4	Remove
	Damper/Duct
	Connector
	from inside
	the hood. Set
	connector
	aside - with
	mounting
	screws and
	parts bag.

DAMPER/

DUCT

CONNECTOR

TEFLON®-COATED BOTTOM COVER

(Held in place with 2 screws)

AIR CHUTE

7	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be care- ful not to discon- nect any wires.

8	Remove Baffle
	from air chute.

	BAFFLE
BAFFLE

5	Remove either
	top or back
	wiring knock-
	out and install
	approved
	Electrical
	Cable Clamp.



ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to Step 15.

	(3) #8 SCREWS	LIGHT
		PANEL
The following
Steps (6 thru	(2) #8 SCREWS
14) are for
DUCTED
INSTALLATION
ONLY.

9

Rotate baffle. Re- insert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the non-ducted slots on top of hood.



SLOTS TABS



6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

	
10	Re-install air chute, re-connect wire
	harness, and replace light panel.
	NOTE: Be careful not to trap wires	SUPPORT FIN
	between support fin and light panel.