Verona VEFSGG 365 N warranty Setting the Burner Minimum, Semirapid and triple ring burners



SETTING THE BURNER MINIMUM

When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when passing suddenly from maximum to minimum flame.

To regulate the flame follow the instructions below:

Semirapid and triple ring burners

–  Light the burner
–  Set the gas valve to	position
–  Remove the knob

– With a thin screwdriver turn the screw "F" until adjustment is correct (fig. 2.7).

Inside crown of DUAL burner

–  Light the DUAL burner
–  Set the gas valve to	position
–  Remove the knob

– Using a screwdriver turn the screw "H" until the correct setting is obtained (fig. 2.8).

Outside crowns of DUAL burner

–  Light the DUAL burner
–  Set the gas valve to	position
–  Remove the knob

– Using a screwdriver turn the screw "G" until the correct setting is obtained (fig. 2.8).

For LP/PROPANE gas, tighten the adjustment screws completely.

regulation

screw

Fig. 2.7

H

G

Fig. 2.8

21