Model
SECTION 5. PRODUCT PROGRAM MODE
5-1. MODIFYING PRODUCT SETTINGS
This mode allows you to program the following:
• Change Product Name | • Include in Filter Count (Global) |
•Assign Button | • Filter at X no. of loads (Mixed) |
• Change Times & Temp | • Load Compensation |
• Change Cook ID | • Load Compensation Reference |
•Alarms | • Full Heat |
• Quality Timers | • PC Factor |
1.Press and hold 
button until “PROG” shows in the display, followed by “ENTER CODE”.
2.Enter code 1, 2, 3 (first 3 product buttons). “PRODUCT” and “PROGRAM” show in the displays, followed by “SELECT PRODUCT’ and
Change Product Names
3.Use the 
and 
buttons to scroll through the 40 products, or press the desired product button.
4. Press 
button and “NAME” shows in the left display and the product (ex: NUGGETS) shows in the right display.
5.Press √ button and the first letter in the name flashes. Press a product button and the flashing letter changes to the first letter under the product button that was pressed. For example, if
is pressed, the flashing letter changes to an “A”. Press the same button again and the flashing letter changes to a
“B”. Press it again and the flashing letter changes to a “C”. Once the desired letter shows in the display, press button to continue to the next letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or press 
button to continue on to “COOK TIME”.
Assign Button
6. Press button until “ASSIGN BTN” shows in the display, along with the product (ex: NUGGETS). If this product already has a product button assigned to it, that LED will be lit. To assign other product buttons to that product, press and hold the product button for 3 seconds and that LED stays lit. To remove a product from a button, press and hold the product button with a lit LED and the LED goes out.
309 |
