Henny Penny EEE-141, EEE-144 Morning Start-Up, Procedures, smoking of oil, or a fire will result

Model EEE-141,142, 143, 144

3-4. MORNING START-UP	1. Make sure basket support is in vat and the vat is filled with oil
PROCEDURES	to the proper level.
	Model EEE-141, fill the oil reservoir. See Section 3-10.
	2. Move power switch to the ON position and then press
	to turn on heat for the desired vat. If display shows “IS POT
	FILLED?” make sure oil is at the proper level (see Section
	3-3) and then press √ button for “YES”.
	Unit automatically goes into the Melt Cycle until the oil tem-
	perature reaches 180°F (82°C) and then control automatically
	exits the Melt Cycle.
	The Melt Cycle may be bypassed, if desired, by pressing √
	button or X button and holding it for 5 seconds.
	The control then shows “EXIT MELT” “YES NO”.
	Press √ button for “YES” and vat heats continuously until the
	set-point temperature is reached.
	Do not bypass the Melt Cycle unless enough oil has melted
	to completely cover all of the elements. If the Melt Cycle is
	bypassed before all elements are covered, excessive
	smoking of oil, or a fire will result.
	DO NOT OVERLOAD, OR PLACE PRODUCT WITH
	EXTREME MOISTURE CONTENT INTO THE
	BASKETS. 3 LBS. (1.4 KG.) IS THE MAXIMUM
	AMOUNT OF PRODUCT PER FULL VATAND 1-1/2
	LBS. (.68 KG.) FOR THE SPLIT VATS. FAILURE TO
	FOLLOW THESE INSTRUCTIONS CAN RESULT IN
	OILOVERFLOWINGTHE VAT WHICH COULD
	CAUSE SERIOUS BURNS, PERSONAL INJURY, FIRE
	AND/OR PROPERTY DAMAGE.
3-7	510