Verona VEFSEE 244 P Levelling the Range, ANTI-TIP Stability Device Installation Instructions



LEVELLING THE RANGE

The range is equipped with 4 LEVELLING FEET (supplied in a separate kit) and may be levelled by screwing or unscrewing the feet (fig. 1.8).

It is important to observe the directions of figures 1.6, 1.7a, 1.7b.

Fig. 1.6

Supplied with the range in a separate kit

0 mm 0"

+5/16"

+8 mm

Fig. 1.7a

YOU MUST USE STABILITY

ANTI TIP BRACKET TO

PREVENT UNIT FROM

TIPPING.

Supplied with the range in a separate kit

+ 5/16" + 8 mm

+ 11/16"	Fig. 1.7b
+ 17.5 mm

Fig. 1.8

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1.The anti-tip bracket has to be attached as shown on figure below (only rear right side), it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws (not supplied).

2.After fixing the anti-tip bracket, slide range into place. Be sure the rear right foot slides under the anti-tip bracket attached.

Dotted line showing the position of the range when installed

=

ANTI-TIP STABILITY

DEVICE FIXING

=

(223

8"	25/32
mm)

Anti-tip stability

Rear right device feet of range

Fig. 1.9

7