Brinkmann 2250 manual Lighting Instructions, Match Lighting the Main Burners

Page 12

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3.Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

NOTE: The CENTER BURNER must be lit first, then light the left and right burners.

3. Push and turn the control knob for the CENTER BURNER to the "HIGH" position.

4.Press the electronic igniter and hold for 3–5 seconds to light burner.

5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.If the CENTER BURNER does not ignite using the push-button igniter, wait 5 minutes, see "Match Lighting the Main Burners" section.

7.To light the left and right burners, push and turn control knobs to HIGH. Follow Step 5.

8.To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the cylinder.

NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

MATCH LIGHTING THE MAIN BURNERS:

1.Open lid before lighting.

2.Turn the burner control knobs to OFF.

3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to approximately 1/2" (1 to 2 cm) from the burner.

4.Turn on the FAR LEFT burner control knob to the HIGH position. The burner should light within 5 seconds.

Lighting Hole

Matchlighter

5.If the burner does not light, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat Steps 1 through 5 until the burner ignites.

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

10

Image 12
Contents 2250Heavy-Duty Gas Grill Page Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Regulator Resetting Procedure Filling the LP GAS CylinderHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorLeak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Side Burner Match Lighting the Side BurnerTurning OFF the Grill Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerCleanliness Grilling to Proper TemperatureHelpful Hints Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCECooking Grills Heat Distribution PlatesTransporting and Storage Before Storing Your GrillTrouble Shooting Frequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions For Missing PARTS, Please Call Customer Service AT Step Hubcap Tank Heat Shield Plate Place grease cup in middle of hole in heat shield plate Grill Body Assembly Hose Heat Shield Step Place side burner grate on side burner Side Burner Igniter Place warming rack in grooves above the cooking grills ProSeries 2250 Assembled Accessories Gallon PAN & Basket SET Warranty