Multiquip MVH-150D Information and related topics, Thus causing serious injury and bodily harm

MVH-150GH/D COMPONENTS (PLATE COMPACTOR)

Figure 1. Compactor Controls

Figures 1 and 2 shows the location of the controls, indicators and general maintenance parts. The function of each control is described below:

1. Breather Cap – Remove this cap to bleed (remove air) the hydraulic system. When replacing hydraulic oil, use "Shell Tellus #46 or equivalent".

2. Hand Grip – When operating the compactor use this hand grip to manuever the compactor.

3. Handle Lock – Pull handle bar downward (working position), then pull handle lock to lock handle bar in place.

4. Vibration Case Oil Level Check Plug – Remove this plug to check the vibration case oil. Oil level should be all the way up to the filler port. When replacing vibration case oil, use 10W-30 engine oil.

5. Handle Bar (working position) – When operating the compactor, this handle is to be in the downward position.

6. Handle Bar (stored position) – When the compactor is to be stored, move the handle bar to the upright position.

7.	Engine – This plate compactor can use either a HONDA
	GX200 gasolineengine or a ROBIN DY23-2Ddiesel
	engine. Refer to the respective owners manual for engine
	information and related topics.
8.	Belt Cover – Remove this cover to gain access to the V-
	belts.NEVER run the compactor without the V-belt cover.If
	the V-belt cover is not installed, the possibility exist that
	your hand may get caught between the V-belt and clutch,
	thus causing serious injury and bodily harm.

9. Vibration Case – Encloses the eccentric, gears and counter weights.

10. Forward & Reverse Lever – Push the lever forward, the compactor will move in a forward direction, pull the lever backwards, the compactor will move in backwards direction. Placing the lever in the middle (midway) will cause the compactor not to move (neutral).

MVH-150GH/D — PARTS & OPERATION MANUAL — REV. #2 (12/04/06) — PAGE 11