Sharp R-530EK service manual Procedure Letter Component Test, High Voltage Rectifier Test

Page 15

R - 5 3 0 E K

R - 530EW

TEST PROCEDURES

PROCEDURE

LETTER

COMPONENT TEST

(HIGH VOLTAGES ARE PRESENT AT THE HIGH VOLTAGE TERMINAL, SO DO NOT ATTEMPT TO MEASURE THE FILAMENT AND HIGH VOLTAGE.)

CHIGH VOLTAGE RECTIFIER TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.Isolate the rectifier from the circuit. Using the highest ohm scale of the meter, read the resistance across the terminals and observe, reverse the leads to the rectifier terminals and observe meter reading. If a short is indicated in both directions, or if an infinite resistance is read in both directions, the rectifier is probably defective and should be replaced.

5.Reconnect all leads removed from components during testing.

6.Reinstall the outer case (cabinet).

7.Reconnect the power supply cord after the outer case is installed.

8.Run the oven and check all functions.

NOTE: Be sure to use an ohmmeter that will supply a forward bias voltage of more than 6.3 volts.

DHIGH VOLTAGE CAPACITOR TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.If the capacitor is open, no high voltage will be available to the magnetron. Disconnect input leads and check for short or open between the terminals using an ohmmeter.

Checking with a high ohm scale, if the high voltage capacitor is normal, the meter will indicate continuity for a short time and should indicate an open circuit once the capacitor is charged. If the above is not the case, check the capacitor with an ohmmeter to see if it is shorted between either of the terminals and case. If it is shorted, replace the capacitor.

5.Reconnect all leads removed from components during testing.

6.Reinstall the outer case (cabinet).

7.Reconnect the power supply cord after the outer case is installed.

8.Run the oven and check all functions.

ECAVITY TEMPERATURE FUSE TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.A continuity check across the cavity temperature fuse terminals should indicate a closed circuit unless the temperature of the cavity temperature fuse reaches approximately 302˚F(150˚C). An open cavity temperature fuse indicates overheating of the oven, exchange the cavity temperature fuse and check inside of oven cavity and for improper setting of cooking time or operation of control unit. Check for restricted air flow through the vent holes of the oven cavity, especially the cooling fan and air guide.

5.Reconnect all leads removed from components during testing.

6.Reinstall the outer case (cabinet).

7.Reconnect the power supply cord after the outer case is installed.

8.Run the oven and check all functions.

MAGNETRON TEMPERATURE FUSE TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.A continuity check across the magnetron temperature fuse terminals should indicate a closed circuit unless the temperature of the magnetron temperature fuse reaches approximately 302˚F(150˚C). An open magnetron temperature fuse indicates overheating of the magnetron. Check for restricted air flow to the magnetron, especially the cooling fan air guide.

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Models R 5 3 0 E K R-530EW Table of ContentsBefore Servicing Dont Touch Before Servicing When the testing is completedMicrowave Measurement Procedure RequirementsLeakage test Foreword Sharp PLAZA, MahwahMicrowave Oven 530EK/ R-530EWGrounding Instructions SpecificationGeneral Information DescriptionTouch Control Panel Oven DiagramDescription of Operating Sequence OperationCooking Sequence MicrowaveFigure O-1. Oven Schematic-Off Condition Description and Function of Components Troubleshooting Guide CK = Check / RE = Replace Power Transformer Test Test ProceduresProcedure Letter Component Test Magnetron Assembly Test Microwave Output PowerHigh Voltage Rectifier Test Procedure Letter Component TestCavity Temperature Fuse Test Magnetron Temperature Fuse TestPrimary Interlock System Test Secondary Interlock Switch TestDoor Sensing Switch Monitor Switch TestTouch Control Panel Assembly Test Before testingBlown Monitor Fuse Test KEY Unit Test Compu Defrost Test Relay TestFoil Pattern on the Printed Wiring Board Test Procedure Component Test LetterWater load cooking test Testing Method for AH Sensor AND/OR Control UnitAH Sensor Test Checking the initial sensor cooking conditionSensor Dummy Resistor Circuit Checking Control UnitTouch Control Panel Assembly LSIIXA098DR Signal coming from touch key Pin No Signal DescriptionSignal synchronized with commercial power source frequency Key strobe signalCommon data signal COM7 Power source voltage GND0VInternal clock oscillation frequency control input setting Common data signal COM8Structure of Absolute Humidity Sensor Common data signal COM9Common data signal COM10 Absolute Humidity Sensor CircuitKRC243M Touch Control Panel ServicingOuter Case Removal Component Replacement and Adjustment ProcedureMagnetron Removal Power Transformer RemovalReinstallation High Voltage Rectifier and High Voltage Capacitor RemovalTurntable Motor Removal Positive Lock Connector NO-CASE Type RemovalControl Panel Assembly Removal Oven Lamp and Lamp Socket RemovalRemoval AH Sensor ReplacementInstallation Cooling FAN Motor RemovalDoor Replacement After adjustment, check the followingRemoval Sealer Film ReinstallationAfter any service, make sure of the following InstallationHigh Voltage Components Figure S-1. Pictorial DiagramFigure S-2. Power Unit Circuit OFF Cook CircuitRY1 RY3 TTM ZD1SP1 VRB RY2Control Panel Parts Parts ListElectric Parts Cabinet PartsSCREWS,NUTS and Washers HOW to Order Replacement PartsDoor Parts MiscellaneousOven and Cabinet Parts Control Panel Parts Door Parts Miscellaneous Packing and Accessories Copyright 2001 by Sharp Corporation ALL Rights Reserved

R-530EK specifications

The Sharp R-530EK is a notable microwave oven that combines functionality with innovation to enhance cooking convenience. With a sleek design and user-friendly interface, this model has earned a place in many kitchens around the globe.

One of the primary features of the Sharp R-530EK is its powerful microwave output. The oven boasts a maximum power of 900 watts, ensuring that food can be heated quickly and evenly. This power level allows users to prepare a variety of meals, from reheating leftovers to cooking dishes from scratch, in significantly less time than traditional cooking methods.

The R-530EK is equipped with a spacious interior, offering 25 liters of capacity. This ample space allows for cooking larger dishes or multiple servings at once. The turntable design ensures even cooking by rotating food during the heating process, further enhancing the microwave's efficiency.

Another standout feature of the Sharp R-530EK is its array of pre-programmed auto-cook menus. These presets simplify cooking by providing specific times and power levels for various types of food, including popcorn, pizzas, and oatmeal. Users can simply select the appropriate setting, and the microwave takes care of the rest, making it ideal for those who may not have extensive cooking experience.

The microwave utilizes advanced inverter technology, a feature that sets it apart from many conventional microwave ovens. Inverter technology allows for continuous and consistent power output, providing more precise temperature control. This means that delicate foods such as seafood or chocolate can be heated without the risk of overcooking or burning, resulting in better texture and flavor.

Additionally, the R-530EK is designed with multiple cooking functions that enhance its versatility. These include defrosting capabilities, grilling options, and even signals indicating the completion of cooking cycles. The easy-to-read digital display and intuitively designed buttons contribute to the overall user experience, making it accessible for individuals of all ages.

Moreover, this microwave oven ensures safety with features such as a child lock, which prevents accidental operation by little hands. The Sharp R-530EK is both an efficient and reliable addition to any kitchen, embodying the perfect blend of cutting-edge technology and practical design to meet the demands of modern cooking. With its impressive range of features and performance capabilities, it stands as a valuable tool for aspiring chefs and busy families alike.
Top Page Image Contents