Before Operation, Setting the Clock | Sharp R-622STM specification

BEFORE OPERATION

Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.

This model has a clock function and the oven uses less than 1.0W in stand by mode.

To set the clock, see below.

SETTING THE CLOCK

Your oven has a 24 hour clock feature.

1.Press the CLOCK/KITCHEN TIMER button once. The hour figure will flash and the clock indicator will illuminate.

2.Rotate the ENTRY dial until the correct hour is displayed, the input time should be within 0-23.

3.Press the CLOCK/KITCHEN TIMER button, the minute figure will flash.

4.Set the minutes. Rotate the ENTRY dial until the correct minutes are displayed, the input time should be within 0-59.

5.Press the CLOCK/KITCHEN TIMER button to start the clock. The icon “:” of the digital time will flash on the display and the clock indicator will disappear.

NOTES:

•If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not been set, the display will show "0:00".

•To check the time of day during a cooking process, press CLOCK/KITCHEN TIMER button and the LED will display the time of day for 2-3 seconds. This does not affect the cooking process.

•In the process of clock setting, if the STOP/CLEAR button is pressed, the oven will go back to the former setting.

•If the electrical power supply to your microwave oven is interrupted, the display will intermittently show "0:00" after the power is reinstated. If this occurs during cooking, the programme will be erased. The time of day will also be erased.

KITCHEN TIMER FUNCTION

You can use the kitchen timer function in instances where microwave cooking is not involved for example to time boiled eggs cooked on conventional hob or to monitor the standing time for cooked/defrosted food.

Example:

To set the timer for 5 minutes.

1. Press CLOCK/KITCHEN	2. Rotate ENTRY dial to select	3. Press the START/+30sec/
TIMER twice.	time .	ENTER key to start the timer.

4.Check the display.

(The display will count down through the programmed time.)

When the timer arrives at 0:00, an audible signal will sound 5 times and the LED will then display the time of day.

You can enter any time up to 95 minutes. To cancel the KITCHEN TIMER whilst counting down, simply press the STOP/CLEAR button. NOTE: The KITCHEN TIMER function cannot be used whilst cooking.

MICROWAVE POWER LEVELS

Your oven has 5 power levels. To select the levels, follow the instruction below.

	To set the power level	LED Display	Microwave Power
•	Press the MICRO.&GRILL button once, P100 will be displayed and		HIGH = 100 %
•
	at the same time the microwave indicator and high heat indicator
	will illuminate on the display.
	will illuminate on the display.
•	Press MICRO.&GRILL or rotate the ENTRY dial to change the		MEDIUM HIGH = 80 %
•	Press MICRO.&GRILL or rotate the ENTRY dial to change the
	power level until the display indicates the desired level.
•	Press the START/+30sec/ENTER button to confirm the setting,


	enter the cooking time and then press the START/ +30sec./ENTER		MEDIUM = 50 %

	button again to start the oven.
• To check the power level during cooking, press the MICRO.&GRILL

	button, the current power level will be displayed for 4 seconds. The		MEDIUM LOW = 30 %
	oven will continue to count down although the display will show		MEDIUM LOW = 30 %
	the power level.
	the power level.

Sharp R-622STM operation manual Before Operation, Setting the Clock, Kitchen Timer Function