Rotel Explore the Comprehensive Setup and Specifications of the RSX 965 Receiver

Page 23

SETUP Menu

SETUP MENU

Front: LARGE

Rear: SMALL

RSX-965

RSX-965 Specifications

Audio

Center: LARGE

Subwoofer: YES

Dynamic Range: OFF

Menu Display: SCREEN

Screen Color: BLUE

DOWN–selection ENTER–change

BACK-return MENU-screen off

The SETUP menu provides status information and configuration options for a variety of system parameters. Some of these settings

Amplifier Power

Frequency Response:

Signal to Noise Ratio (IHF “A”):

(Dolby Digital)

75 watts per channel into 8 ohms x 5 chan. all channels driven, from 20 Hz to 20k Hz,

< 0.05 THD

100 w/ch, 8 ohms, 1kHz, 1% THD, DIN

5 Hz - 20 kHz, + 0.5 dB

92 dB (Stereo), 70 dB

duplicate the function of front panel controls.

Note: See the discussion of speaker configuration under the SPEAKER MODE button heading in the Front Panel Controls sec- tion of the manual. Detailed instructions for choosing speaker types are presented there.

FRONT: whether the front speakers are LARGE (full bass re- sponse) or SMALL (limited bass output)

REAR: whether the rear speakers are LARGE, SMALL, or NONE

CENTER: whether the center speaker is LARGE, SMALL, or NONE

SUBWOOFER: whether there is a subwoofer in the system: YES or

NO

DYNAMIC RANGE: whether the dynamic range compression is turned OFF (full dynamic range/no compression), MID (moderate dynamic range/moderate compresson), or MIN (minimum dynamic range/maximum compression)

MENU DISPLAY: determines whether status information will ap- pear on screen when volume, input, or other selections are made

– choices are SCREEN (display on) or OFF (display off).

SCREEN COLOR: selects a background color for the on screen dis- play.

Change any setting by moving the cursor to the desired line using the UP/DOWN buttons on the remote or the NUMERIC Keypad front panel buttons (), change the setting by pressing the EN- TER button to step through the choices. Return to the MAIN menu by pressing the BACK button. Cancel the On-Screen Display by pressing MENU.

Input Impedance:

47 k Ohms

Output Impedance:

500 ohms

Total Harmonic Distortion:

0.05 % (@1 kHz)

Intermodulation Distortion:

0.03 % (400 Hz/7 kHz, 4:1)

Output

 

Maximum:

> 6 volts

Dolby, 200 mV in:

1.1 volt

Video

Frequency Response:

3 Hz-10 MHz, - 3 dB

Signal to Noise Ratio:

45 dB

Input Impedance:

75 ohms

Output Impedance:

75 ohms

Output level (peak to peak):

1 volt

General

Power Consumption:

400 watts

Power Requirements (AC):

115 volts 50/60 Hz or

 

230 volts 50/60 Hz

Weight:

15 Kg/33 lb.

Dimensions (W x H x D):

450 x 158 x 400 mm

 

173/4" x 61/4" x 153/4"

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.

DTS is a registered trademark of Digital Theater Systems.

Dolby Pro Logic and Dolby Digital are registered trademarks of the Dolby Licensing Corporation.

23

Image 23
Contents RSX-965 Risk of Electric Shock Do not Open RSX-965 Remote Control Output Connections RCA Input Connections Video Input Connections On-Screen Menus Contents Front Panel Basic Controls About RotelGetting Started Front Panel Input Selection/ Recording Controls PRO Logic Button Front Panel Surround Sound ControlsCH Input 14 Video 1 REC ButtonDynamic Range Button Front Panel Tuning ControlsTuning Button 27 DSP ButtonFront Panel Configuration Controls Menu Button 12 Surround modeRR-939 Remote Control Rear Panel Video Source Connections Rear Panel Connections OverviewRear Panel Audio Source Connections Rear Panel Output Signal Connections Rear Panel Antenna Connections On-Screen Display and System Configuration Rear Panel AC Power ConnectionsTest Tone Menu Surround Mode MenuTONE/BALANCE Menu Bass Level MenuSurround Level Menu Video RSX-965 SpecificationsSetup Menu AudioRSX-965