Rotel Essential Safety Guidelines for Your RSX 1065 Stereo Receiver

Page 2

Important Safety Instructions

WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel.

WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately dis- connect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs.

Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions.

Heed all warnings and safety information in these instructions and on the product itself. Follow all operating instructions.

Clean the enclosure only with a dry cloth or a vacuum cleaner.

You must allow 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation openings. If the unit is placed in a bookcase or cabi- net, there must be ventilation of the cabinet to allow proper cooling.

Keep the component away from radiators, heat registers, stoves, or any other appliance that produces heat.

The unit must be connected to a power supply only of the type and voltage specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)

Connect the component to the power outlet only with the supplied power supply cable or an exact equivalent. Do not modify the supplied cable. Do not defeat grounding and/or polarization provisions. The cable should be connected to a 2-pin polarized wall outlet, matching the wide blade of the plug to the wide slot of the receptacle. Do not use extension cords.

Do not route the power cord where it will be crushed, pinched, bent, ex- posed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit.

The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time.

Immediately stop using the component and have it inspected and/or ser- viced by a qualified service agency if:

The power supply cord or plug has been damaged.

Objects have fallen or liquid has been spilled into the unit.

The unit has been exposed to rain.

The unit shows signs of improper operation

The unit has been dropped or damaged in any way

NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installer’s attention to Article 820-40 of the NEC. This provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. See installation diagram.

NOTE: This equipment has been tested and found to comply with the lim- its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. This equipment generates and can radiate ra- dio frequency energy and, if not installed and used in accordance with the instructions, may cause interference to radio or TV communications. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, try to cor- rect the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the unit and the television tuner.

Connect the unit to an AC power outlet on a different electrical circuit.

Consult your authorized Rotel retailer for assistance.

Image 2
Contents RSX-1065 Important Safety Instructions Controls and Connections 28 29 31 32FL Display RR-969 RemoteOutputs SubwooferRSX-1065 Surround Sound Receiver Audio InputsVideo Inputs Zone 2 Connections Antenna On-Screen Display Menus Input LabelContents Unpacking Key FeaturesPlacement Basic Controls Input Controls DSP Button PRO Logic II ButtonStereo Button 2CH ButtonSUR+ Button Speaker Level Adjustment Selection Buttons UP/DOWN ButtonsTuner Controls Dynamic Range Button DWN ButtonPreset Button Tuning ButtonsNumeric Buttons Station Presets Band ButtonTP Button Display ButtonPTY Button TA ButtonTape Inputs and Outputs Video ConnectionsCD Inputs Video Source Outputs Video 1-3 S-Video Outputs Video 1-3 Audio OutputsComposite Video Outputs Digital InputsRCA Preamp Outputs FM Wire AntennaAccessory Power Outlets North American version AM Loop AntennaControlling Zone 2 from the Main Room Zone Button Zone 2 Power On/Off OperationComputer I/O Keypad Zone REM in Jack Controlling Zone 2 from the Remote LocationZone 2 Audio Outputs IR OUT JacksSystem Status Menu ConfigurationNavigation Buttons Main MenuSpeaker Setup Menu Input MenuSurround Speakers small/large Delay Setup MenuCenter Speakers small/large Center Back Speakers smallOther Options Menu Subwoofer Setup MenuTest Tone Menu To activate memorized User Default Default Setup MenuTo restore the Factory Default set AM Tuner Zone 2 Setup MenuAudio VideoPage Rotel Deutschland Rotel of AmericaRotel Europe