Rotel RSP-1066 owner manual FCC Information

Page 2

Notice

The COMPUTER I/O connection should be handled by authorized person only.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radi- ate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communica- tions.

However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.(TV, radio, etc.)

Increase the separation between the equipment and receiver

Connect the equipment to an outlet on circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for additional help.

Caution

This device complies with part 15 of the FCC Rules operation is subject to the following to conditions: (1) This device may not cause harmful interfer- ence, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Image 2 Rotel RSP-1066 owner manual FCC Information
Contents RSP-1066 FCC Information Important Safety Instructions RSP-1066 Controls and ConnectionsPower VOL RR-969 RemoteOutputs CenterInputs DVDZone 2 Connections Trig OUTOn-Screen Display Menus Contents About Rotel Key FeaturesPlacement Getting StartedBasic Controls Input Controls DTS Dolby Surround Dolby Pro LogicDolby Digital 7.1 Surround DSP Digital Signal ProcessingSurround Controls Other FormatsDolby PLII/3ST Button Manually Selecting Surround Modes2CH Button DTS Neo6 ButtonDSP Button Setting Surround Modes from the Remote SUR+ ButtonSpeaker Level Adjustment Selection Buttons UP/DOWN Buttons Dynamic Range Button DWN ButtonCD Inputs Video Source InputsVideo Connections Tuner InputsVideo 1-5 S-Video Inputs Video 1-5 Audio InputsComposite Video Inputs Component Video InputsDigital Inputs Digital OutputsPreamp Outputs TV Monitor Output12V Trigger Connections Computer I/OControlling Zone 2 from the Remote Location Zone 2 Power On/OffControlling Zone 2 from the Main Room Zone Button Zone 2 Audio OutputsMain Menu Navigation ButtonsSystem Status Menu DOWN/UP Buttons To move upDTS Neo6 Sub-Menu Dolby PRO Logic II Sub-Menu Input Setup MenuDolby Pro Logic II surround mode Speaker Setup Menu WooferCenter Back Speakers small Test Tone MenuSurround Speakers small/large CB Spkr Select 1 speaker/2 speakCalibration with an SPL meter Delay Setup MenuSubwoofer Setup Menu Other Options Menu Default Setup MenuTo restore the Factory Default set Audio SpecificationsZone 2 Setup Menu VideoRotel Deutschland Rotel of AmericaRotel Europe