321 Studios 7322 230 user manual Hob or the cooking zone doesn’t start-up

3)The left display shows alternatively a [ C ] and a [ 0 ]

4)Press the key lock until both displays indicate either [ C ] or [ - ].

5)Take your fingers away from the keys and press again the [ - ] key during a few seconds until some [ E ] appear.

6)You will hear a "beep" sound and the [ E ] will blink.

7)The [ E ] are automatically transformed into [ C ] → The configuration has been canceled.

VI) How to configure the hob ?

1)Use a suitable induction pot with a minimum diametre size of 16cm.

2)Select the heating zone by pushing the corresponding [ + ] key.

3)Put the pot on the corresponding heating zone.

4)Wait until [ C ] converts to [ - ]. The zone is configured

5)Use the same procedure for each other heating zone which displays [ C ]

6)The configuration is made if all zones are detected and if nothing is displayed Use only 1 pot to configure the hob.

Never put two or more pots on the heating zones during the configuration.

∙If [ E 4 ] display persists call the After-sales Service

The hob or the cooking zone doesn’t start-up

∙The hob is badly connected on the electrical network.

∙The protection fuse cut-off

∙The locking function is activated

∙The sensitive keys are covered of grease or water.

∙An object is put on a key.

The symbol [ U ] displays

∙There is no pan on the cooking zone.

∙The pan is not compatible with induction.

∙The bottom diameter of the pan is too small.

The symbol [ C ] or [ E ] displays

∙Call the After-sales Service.

One or all cooking zones cut-off

∙The safety system functioned

∙You forgot to cut-off the cooking zone for a long time.

∙One or more sensitive keys are covered.

∙The pan is empty and its bottom overheated.

∙The hob also has an automatic reduction of power level and breaking Automatic overheating

Continuous ventilation after cutting-off the hob

∙This is not a failure, the fan continuous to protect the electronic device.

∙The fan cooling stops automatically.

11