FoodSaver V1085 quick start Getting Started, How to Make a Bag from a FoodSaver Roll

QS.1085_v2.1 5/26/04 11:32 AM Page 2

Getting Started

Registering your appliance is quick and easy at www.foodsaver.com.

How to Make a Bag from a FoodSaver Roll

Place Bag on Sealing Strip			Set Seal Control Switch		Press and Release Lid
1.	Cut enough bag material from roll to hold item			5.	Press down firmly on lid with both hands until
	to be vacuum packaged, plus 3 inches. Be sure to				motor starts, wait 3-5 seconds, then release.
	cut straight.				Motor will continue to run.
2.	Open appliance lid and place one end of bag			6.	When motor and Indicator Light (A) turn off,
	material across Sealing Strip (H), not over				press Open/Cancel Button (B) to open lid and
	rubber gasket (J).				remove bag.
3.	Close lid.			Now you are ready to vacuum package with your
4.	Turn Seal Control Switch (E) to		.
		1
				new bag (see below).

How to Vacuum Package with FoodSaver Bags								Rolls
								&
Place Bag in Vacuum Channel				Set Seal Control Switch
							Press and Release Lid
1.	Place item(s) in bag, allowing at least 3 inches of				5.	To begin vacuum process, press down firmly on lid
	space between bag contents and top of bag.					with both hands until motor starts, wait 3-5 seconds,
2.	Open appliance lid and place open end of bag					then release. Motor will continue to run.
	down into Vacuum Channel (G).				6.	When motor and Indicator Light (A) turn off, press
3.	Close lid.					Open/Cancel Button (B) to open lid and remove
4.	Turn Seal Control Switch (E) to:					bag. Refrigerate or freeze if needed. (See FoodSaver
			for vacuum and seal.			Reference Guide for food safety tips.)		Bags
		1
			to vacuum and extended seal (for moist or
		2			Note: Let appliance cool down for 20 seconds
			juicy foods such as raw meat).
					after each use.