General, Installation, Unpacking, Location

Installation, Operation, and Care of

BERKEL FMS10 & 20 Quart MIXER

SAVE THESE INSTRUCTIONS

GENERAL

The 10 quart mixer has a DC electric motor and motor control. A 10 quart bowl, bowl guard, B-Flat beater, spiral dough hook, D wire whip and ingredient chute are shipped as standard equipment. A 0-15 minute timer and four plastic foot pads are standard.

The 20 quart mixer has a DC electric motor and motor control. A 20 quart bowl, bowl guard, B-ﬂat beater, spiral dough hook, D wire whip and ingredient chute are shipped as standard equipment. A 0 - 15 minute timer and four plastic foot pads are standard. A #12 attachment hub is standard. A variety of attachments are available. A 10 quart bowl and its associated accessories are optional.

INSTALLATION

UNPACKING

Immediately after unpacking the mixer, check for possible shipping damage. If the mixer is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

Prior to installation, test the electrical service to assure that it agrees with the speciﬁcations on the machine data plate.

LOCATION

Remove hex head shipping bolts with a 3/8" wrench (or crescent wrench), that attaches the four legs to the base-frame of the carton.

Place the mixer on a suitable sturdy level surface. There should be adequate space around the mixer for the user to operate the controls and install and remove bowls.

ELECTRICAL CONNECTIONS (Cord Connected Mixers)

The electrical cord on this machine is equipped with a three-pronged grounding plug which must be connected to a properly grounded receptacle. If the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding prong from the plug.

FMS10 & FMS20 Owner/Operator Manual

– 3 –