Output Connections | Altec Lansing digital signal processor, 4948A

Operating Manual -4048A digital signal processor

5.REAR PANEL FEATURES 5.1 Input Connections

Balanced input signals are connected to the 4048A using the included "Euro Block" connector. A flat blade screwdriver is required to connect a stripped wire lead to the loose connector, which is then inserted into the rear panel Euroblock receptacle. It is important that both (+) and (-) inputs are properly terminated or signal loss and noise may result. In other words, if an unbalanced input signal is used, con- nect the signal to the (+) input, and connect the ground wire to both the (-) and ground connection.

A Note About Input Signal Levels:

+ - G

Euroblock + - G

Connector

System

There are no input trim adjustments on the 4048A, therefore all the processing (including gain) is done in the digital domain. As a consequence of this design philosophy, it is important to feed the processor with the proper nominal signal level to achieve good signal to noise performance as well as headroom before clipping. The 4048A is designed to clip at signal levels above +20dBu = 7.75Vrms which places the noise floor lower than -90dBu. The optimum input signal level which should be fed into the processor is 0dBu = .775Vrms. This input level will allow 20dB of headroom while giving a nominal signal that is >90dB above the noise floor.

5.2 Output Connections

Like the inputs, output connections are made using the included Euroblock connector. All outputs are elec- tronically balanced, and may be wired balanced or unbalanced. For unbalanced outputs, connect the shield to both (- ) and G terminals.