Nespresso M100 specifications 300, 600, 1200, Emergency Immediately remove plug from power socket

Magimix_D100_0605_1 14.7.2005 11:28 Uhr Seite 2

Coffee button Coffee outlet

Lever	3 Espresso	Lungo
	Preparation

C M Y CM MY CY CMY K

4Daily: After the last coffee

7Descaling

Carefully read safety instructions on decalcifier package. Decalcifier is aggressive to surface of casing.

Water hardness		Descale after
fH	dH

8Troubleshooting

a

Safety precautions	This appliance may become a safety
Keep this instruction manual	hazard if these instructions and
	safety precautions are ignored.

Coffee button

Capsule container for 12 - 14 capsules*

Drip grid*

Drip tray*

		1.	3.
Water tank*		2.
		or
ON/OFF switch	Preheat cup: 1 cup of water	Insert capsule
* Spare parts

Switch off	Empty capsule	Rinse and empty
	container + drip tray	water tank

Preparation

1.2.

a

36	20	300
18	10	600
0	0	1200

no light		Check mains: plug, voltage, fuse. In case of problems
		call Nespresso Club
No coffee,
no water	Water tank empty –> fill water tank
b	Start	2.	Stop
	Venting	1.
		1. Open + 2. push and hold for 3 secs		Close

Emergency:

Immediately remove plug from power socket.

This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to

comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Remove plug from from socket if not in use for long periods - holiday etc.

Check that the voltage quoted on the rating plate is the same as your

-Always close lever, never lift during operation. - Do not put fingers into capsule compartment and

capsule shaft, danger of injury. - Do not use appliance without drip tray and drip grid.

- Keep appliance/cable out of reach of children.

Do not place power cord on or near hot parts or sharp edges etc.

- Never touch the cable with wet

hands. - If damaged, do not use the appliance.

In order to avoid danger, all repairs to the power

Children may never use the appliance without close adult supervision.

Before cleaning/care, unplug the appliance and let it cool down.

-Never immerse either the whole machine, power cord or plug, in water or any other fluids.

Descaling:

7c) Do not lift lever during descaling process. 7d) Rinse the

1First use or after a longer period of non-use

or
Flow speed depends on coffee variety	Eject capsule (drops into
	capsule container)

Damped cloth, cleaning agent mild

abrasive solvent container dishwasher

Remove capsule	Empty capsule
	container + drip tray

b

Rinse machine, see 1			If leakage
			see:
			8d
2.	1.	3.

	Descale, if necessary –> point 7
	Coffee not hot enough	Preheat cup, descale if necessary
c

voltage. - Connect the appliance only to power sockets with protective earth. The use of incorrect connection voids warranty.

Place on a flat, stable heat-resistant work surface away from water splashes and any heat sources.

Do not use machine if it is not in perfect working order, or if there is any evidence of damage. In such

cord, must only be carried out by the Nespresso's

authorised service agent.

Do not open appliance and do not

put anything into openings.

All operations other than normal use, cleaning and care must be performed by Nespresso Club.

water tank and clean the machine to avoid any residual descaling agent.

Packaging is made of recyclabe materials

Unplug the machine and cut off the power cord near housing. Dispose of machine and cable at your public disposal depot, or contact Customer Services for further assistance.

Remove plastic film Fill water tank	Place a container	Plug into mains +
		switch ON

Programming the fill up level

1.	3.
2.
	or

6Empty system: After long period of non-use, for frost protection and after repair.

Switch off and remove Press small cup button & switch on Buttons blink alternatively

Fill with Nespresso	Place a recipient		1. Lift lever, 2. insert filter, 3. close lever 1.
descaler and 0.5 l water
Descaling	Vinegar damages your machine.
c	Start	90 sec	Stop

d	Capsule area leaking		Position capsule correctly.
	(water in drip tray)		If leakage: call Nespresso Club
		Irregular interval blinking	Send machine to repair or call Nespresso Club
e

cases inform Nespresso Club immediately for further assistance.

FOR UK AND REPUBLIC OF IRELAND ONLY

WARNING: Always replace the fuse cover of the fitted plug, never use the plug with the fuse cover omitted. If a replacement fuse cover is required, ensure it is the same as the one visible on the pin face of the plug (i.e. RED or ORANGE).

Fuse covers are available from: BBS Ltd Po Box 110

Heating up	Ready	Rinse: let water run through 6x
		No water	see: 8b

Insert capsule	Press and hold button for at least 3 seconds,
	release at desired level

water tank simultaneously

Press both buttons	Let descaling solution	Refill water tank once more
simultaneously for 3 seconds	run through	with descaling solution and
		repeat step

Let descaling solution run through once again

Specifications

. . . . . 220 - 240 V, 50 Hz, max. 1260 W

Optional Accessory

Farnham Surrey GU104XL Phone : 01252 727755

Use a 13 A fuse approved by ASTA to BS1362, marked thus

WARNING: a plug with a bared flexible cord is hazardous if engaged in a live socket. If the fitted plug has been cut from the power supply cord, it should be destroyed and replaced with a three pin plug in

M100 Automatic

Instruction Manual

460 157

2Daily: before the 1st coffee

Resetting the programmed large and small coffee flows to factory settings

Fill water tank with	Switch ON	Heating up	Ready	Switch OFF	Press and hold big cup button for 3 secs.	Switch ON
fresh water

2.

1.

1. Open	Close	Switch off (machine blocks for 10
2. push and hold for 3 secs.		min and is ready to be transported)

Rinse

d					+
	Remove filter	Empty, rinse and fill water	Rinse machine,	Exit: press both buttons
		tank with fresh water	see 1	simultaneously for 3 secs

. . . . .	max. 19 bar
. . . . .	~ 3 kg
. . . . .	1 l
. . . . .	5 oC ... 45 oC
. . . . .	16.6 cm	25.2 cm	29.1 cm

Nespresso descaling kit

accordance with the following code: BLUE : neutral

BROWN : live

GREEN/YELLOW : earth

The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter “N” or coloured BLUE or BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter “L” or coloured BROWN or RED which is connected to the fuse.

The wire which is coloured GREEN/YELLOW should be connected to the terminal marked with the letter “E”, or by the earth symbol or coloured GREEN or GREEN/YELLOW.

earth symbol

Please read this Instruction Manual and the safety instructions before operating the appliance!

ref :

TSM SUCCESS MANUAL® Safe to use - easy to understand due to	0505_5
TSM® - Total Security Management and ergonomic communication®

Probedruck