CASH DRAWER

The PST7700 installed with power management kit option is able to control most of the common cash drawers available on the market. However, it is recommended that the Posiflex CR-3100 or CR-3200 or CR-4000 or CR- 4100 or CR-4210 be used since the terminal has been designed to compliment these cash drawers both mechanically and electrically.

The PST7700 will directly control the cash drawer using the cash drawer port (CR) both to operate the opening mechanism and to monitor the drawer open status. Both functions may be accomplished under software control of the COM1 serial port.

Use the cable supplied with the CR-3X00/4X00 cash drawer (Part No. CCBLA-180) for connection to the CR port in PST7700. This cable has a 6 pole plug at one end and a 8 pole plug at the other. The 8 pole plug should be inserted into the connector marked: “signal cable from POS Printer” at the rear of the cash drawer. The 6 pole plug should be inserted in the connector marked “CR” found in the rear room of the terminal.

The user may also use the optional 2-in-1 cash drawer control cable CCBLA-238 to control 2 cash drawers in 1 port. It has a 6 pole plug at one end and two 8 pole plugs at the other. The 6 pole plug should be inserted in the connector marked “CR” found in the rear room of the terminal. Each 8 pole plug should be inserted into the connector marked “signal cable from POS Printer” at the rear of one of the cash drawers. The cable lengths for the two 8 pole plugs are different. Use the shorter one for the original cash drawer “CR1” and use the longer one for the extended cash drawer “CR2” that will be distinguished by the software command.

AC POWER

The power supply operating voltage must be checked and altered if necessary. This must be done WITHOUT any connection to the AC power.

The operating voltage adjustment switch is located close to the power input connector in the rear room.

The switch should indicate either 115 volts or 230 volts. When set at 115 volts the acceptable power supply voltage range is 90 volts to 130 volts whilst at 230 volts the acceptable power supply voltage ranges from 190 volts to 260 volts.

The power supply cable should first be connected to the power inlet (but NOT the wall socket). This cable should be secured to the latticed bottom of the rear room using a cable tie provided. The cable may exit either at the side or back of the rear compartment by using the relevant breakout section in the chassis plastic molding.

Part 12

Page 12
Image 12
POSIFLEX Business Machines PST - 7700 user manual Cash Drawer, AC Power