The next step is to |
| Monitor | Mounting | |
pass the monitor cable through |
| Hook | Lugs | |
a square hole at the back edge |
|
| Mounting | |
of main unit. Open the back |
|
| ||
|
| Holes | ||
door by sliding two back door |
|
|
| |
latches at the bottom of back | Bowl |
|
| |
door toward the center. The |
|
| ||
back door is easily removable. |
|
|
| |
Remove the cable cover by |
|
|
| |
pulling the latch on the |
|
|
| |
underside of the cable cover |
|
|
| |
(ref. drawing below). Connect |
|
|
| |
the VGA cable to the VGA |
|
|
| |
connector through this opening |
|
|
| |
then put the cable cover back |
| VGA Connector | ||
onto the square hole with the hook |
|
| ||
end in position first and then press |
|
| ||
the cover down to position. You will |
|
| ||
hear another click sound and the |
|
| ||
cable cover is well mounted. |
|
|
| |
To remove the monitor, first |
|
| ||
disconnect the cable then pull the |
|
| ||
latch on the underside of the cable |
|
| ||
cover to remove the cable cover. |
|
| ||
Then pull the monitor hook lever at | Latch | Cable Cover | ||
rear bottom of the bowl by finger, | ||||
|
| |||
then raise and rotate the monitor forward till the CRT front is facing downward.
LCD CASHIER DISPLAY
When the PST7705 or PST7735 is ordered, the user has to take the 12.1” TFT LCD cashier display out from the cashier display carton and assemble it onto the main unit per following instructions.
Unscrew and take out the pivot that is screwe d on the display platform of the main unit. Unfold the base of the operator display and insert it into the opening on the display
Pivot 
12.1” LCD
Base Of
LCD
Cable Cover
Part 8
